Thermal Wave INFRARED FIREPLACE, Руководство по эксплуатации и гарантия

Страница: 4 / 8

4
FIREPLACE OPERATION
Plug your Infrared fireplace heater power cord into a 120V, 15 amp or 20
amp three bladed outlet.
To Set Flame Brightness: Use the Dimmer button (4) on the control
panel or remote control. The flame brightness control button is used to
increase or decrease the brightness of the flame and ember.
Press
once, the brightness will start and keep changing. Press again to set
the desired level.
Remote Control
Control Panel
To Set Flame Brightness: Use the Dimmer button (4) on the control
panel or remote control. The flame brightness control button is used to
increase or decrease the brightness of the flame and ember.
Press
once, the brightness will start and keep changing. Press again to set
the desired level.
To Turn the Heater On: Press the
Power button (1) on the control
panel or on the remote control.
To Set the Temperature: Press
the Up or Down button(2) on the
control panel or on the remote con-
trol to the desired temperature.
When desired temperature is
reached, the heater will stop heat-
ing automatically. When the temperature
drops below the desired temperature, the
heater will come on again.
The default display is the set temperature. To
display the room temperature, press and hold
the Up button for 3 (three) seconds, and then
the room temperature will display for 5 (five)
seconds.
Please note: The fan may run up to 2.5
minutes after heating has stopped. This is
NORMAL!
To Set the Heating Level: Press the Heat
button (3) on the control panel or the remote
control to switch between high and low heat
and the corresponding High (H) or Low (L)
LED will be lit. The high heat level uses 1500
watts for rooms up to 1000 square feet. The
low heat level uses 1000 watts for rooms up to
500 square feet.
To Change Between °C and °F: Press the
C/F button (5).