Thermal Dynamics PCH-100XL, Инструкция по эксплуатации

Страница: 20 / 48

INSTALLATION PROCEDURES 14 Manual 0-2583
Workpiece
Rack and
Pinion Mounting
Assembly
Square
A-00934
Figure 3-1 Machine Torch Set-Up
3. The proper torch parts (shield cup, tip, gas dis-
tributor, and electrode) must be installed for the
type of operation. Refer to Section 4.04, Torch Parts
Selection for more information.
3.06 Connecting Torch
WARNING
Disconnect primary power at the source before dis-
assembling the torch or torch leads.
1. Connect the torch lead connections to the Power
Supply as described in the Manual supplied with
the Power Supply.
Control Cable
Pilot Lead
Torch Lead
Assembly
Gas Lead
A-00935
Figure 3-2 Torch Lead Connections
2. Check the torch for proper parts assembly.
CAUTION
The torch parts must correspond with the type of
operation. Refer to Section 4.04, Torch Parts Se-
lection.
3. In machine type operations the Machine Torch
(PCM-100XL) has an extra cable connector sup-
plied at the control cable connector. This connec-
tor allows connection to a remote pendant or CNC
cable while using PIP connections in the Torch As-
sembly. Connect the remote pendant control cable
to the lead connector provided on the Torch leads.
2
3
4
12
14
13
Torch Control
Cable Connector
Remote Pendant/CNC
Cable Connector
PIP
Circuit
Control
OK-To-Move
3
4
12
14
13
A-01366
Figure 3-3 Remote Pendant Connector Diagram
3.07 Gas Connection
A. Connection
Connect the gas , compressed air or nitrogen (N2) only,
to the Power Supply as described in the Manual sup-
plied with the Power Supply.
CAUTION
Air supply must be free of oil, moisture, and other
contaminants. Excessive oil and moisture may
cause double-arcing, rapid tip wear, or even com-
plete torch failure. Contaminants may cause poor
cutting performance and rapid electrode wear.
B. Checking Air Quality
To test the quality of air, place a welding filter lens in
front of the torch and turn on the gas. Any oil or mois-
ture in the air will be visible on the lens. Do not ini-
tiate an arc!