Thermal Dynamics Pak Master 100XL, Руководство по эксплуатации, Страница: 22 / 46

INSTALLATION PROCEDURES 16 Manual 0-2581
Two Stage Filter
Assembly
1/4 NPT to
#4 (6mm) Hose
Fitting
#4 (6mm) Gas
Supply Hose
Hose Clamp
A-00917
Figure 3-9 Gas Connection To Optional Two Stage
Filter Assembly
5. Refer to the following when using high pressure gas
cylinders as the gas supply:
CAUTION
Pressure should be set at 100 psi (6.9 BAR or 690
kPa) at the high pressure gas cylinder regulator.
a. Refer to the manufacturer’s specifications for in-
stallation and maintenance procedures for high
pressure gas regulators.
b. Examine the cylinder valves to be sure they are
clean and free of oil, grease or any foreign mate-
rial. Momentarily open each cylinder valve to blow
out any dust which may be present.
c. The cylinder must be equipped with an adjustable
high-pressure regulator capable of outlet pressures
up to 100 psi (6.9 BAR or 690 kPa) maximum and
flows of up to 400 scfh (188.7 lpm).
6. Slide the gas supply hose over the barb fitting installed
in Step 2.
7. Secure the gas supply hose to the Barb fitting with the
adjustable hose clamp.
NOTE
Supply hose must be at least #4 hose (1/4 in or 6
mm I.D.).
3.09 Connecting Torch Leads
WARNING
Disconnect primary power at the source before as-
sembling or disassembling the power supply, torch
parts, or torch and leads assemblies.
The Torch Leads must be properly installed to the Power
Supply for proper operation. Make all torch connections
to the Torch Bulkhead Panel per the following:
NOTE
Equipment ordered as a system will have the Torch
factory connected to the Power Supply.
1. Turn the screw latch securing the front access panel to
the power supply front panel.
Access Panel
Screw Latch
A-01348
Figure 3-10 Front Access Panel
2. Lift up on the access panel to gain access to the torch
bulkhead panel.
CAUTION
This system is designed for use with the PCH/M-
100XL torch only. Do not connect any other torch
to this power supply.
3. Remove the securing nut from the strain relief sup-
plied on the end of the Torch Leads.