Thermal Dynamics IHC XT, Руководство по эксплуатации

Страница: 34 / 70

iHC XT
4-6 OPERATION Manual 0-5352
4.09 Advanced Parameters
Parameter name Default Description
Encoder pulses Motor steps/meter
Home distance Distance from upper limit switch
High jog speed Manual up/down speed while not
cutting
Low jog speed Manual up/down speed while cutting
Plate c. rel. speed Speed when retracting from plate
Slow down height Height to slow down during IHS
Hold off AVC delay Delay to enable AVC after hold signal
goes OFF
Adjust speed Maximum speed in AVC control
Hold on limit Voltage to disable AVC control on kerf
crossing
Hold off limit Voltage to recover AVC control on kerf
crossing
Transfer height Raise height between pierces
Homing speed Speed during lifter homing
Main arc lost time out Time to stop cutting after main arc
signal is lost
Upper sw limit distance Upper software limit distance from
hardware switch
Lower sw limit distance Lower software limit distance from
hardware switch
Transfer height time-out Time after the lifter moves from trans-
fer height to home position
Full Speed Maximum speed
Manual acceleration Acceleration when moving torch
manually
Machine acceleration Acceleration when in automatic mode
Voltage gain Gain setting in AVC
Manual deceleration Deceleration when moving torch
manually
Machine deceleration Deceleration when in automatic mode
Collis. retract height Distance moved to prevent collision
Collis. recovery delay Time to recover to AVC from retract
height
Arc shutdown voltage Voltage level to determine plasma arc
is OFF
Total starts Number of plasma starts detected
Arc on time Time that plasma arc has been ON
Out of material time Time cut out of material
Out of material count Number of cuts out from plate
IHS enabled Initial height sensing enabled/disabled
Collision retract
Automatically retract from plate
if plate contact has happened
during cutting
Torch collision polarity Torch collision sensor input polarity
Ohmic plate contact Ohmic sensing enabled/disabled