Thermal Dynamics 51 CUTMASTER, Руководство по обслуживанию

Страница: 38 / 88

TROUBLESHOOTING 4-18 Manual 0-2972
2. Measure for approximately 28 VAC on coil of Con-
tactor between wires #11 and #12.
• If voltage is correct, replace Main Contactor. If
voltage is incorrect, replace Main PC Board.
F. Gas Solenoid Circuit Test
Make the following voltage checks and replace the faulty
part as required.
1. Place the RUN/RAPID AUTO RESTART/SET
Switch to the SET position.
2. Measure for 28VAC across Solenoid wires #7 and
#8.
• If 28VAC is present, replace Solenoid/Pressure
Switch Assembly. If 28VAC is not present, go to
the next step.
3. Check voltage at J1-14 to TP1 on Logic Board.
• If less than 2vdc replace Main Power PC Board.
If more than 2vdc, replace Logic PC Board.
G. IGBT Board/Output Diode Circuit Test
1. No DC Output
When the unit is at “idle” the AC indicator on the
Front Panel should be ON. When the torch is acti-
vated, the gas begins to flow. When the preflow time is
over, the INV ON indicator on the Logic PCB energizes,
and the DC indicator on the Front Panel turns ON.
• If the INV ON indicator does not turn ON, then
replace the Logic PCB.
• If the INV ON indicator turns ON then OFF imme-
diately, the following test should be performed:
a. Disconnect eight-pin wire harness connector
from the Pilot PC Board.
WARNING
The connector on the Pilot PC Board must be dis-
connected to prevent electrical damage to measur-
ing equipment when testing the open circuit volt-
age (OCV).
b. Activate torch (Logic PC Board Inverter On In-
dicator, turns ON).
c. Measure for more than 200 vdc between E7(+)
and E10 (-) on the Main PC Board. If voltage is
less than 10 vdc, each
IGBT Module and Out-
put Diode Module should be tested individu-
ally.
2. Output Diode Circuit Test
WARNING
Disconnect primary power at the source before tak-
ing any resistance checks.
a. Use an ohmmeter set to the diode function and make
the following measurements on the Output Diode
Board to Main Power PC Board.
Meter (+) Meter (-) Indication
E18 E21 Diode Drop
E21 E18 Open
E18 E20 Diode Drop
E20 E18 Open
E20 E19 Diode Drop
E19 E20 Open
E21 E19 Diode Drop
E19 E21 Open
E18 E19 (2) Diode Drops
E19 E18 Open
b. The meter should indicate a diode drop in one di-
rection and an open in the other direction for each
check. Replace Output Diode Board if readings are
not the same as the chart.