Thermal Arc TA-8/300-KAT, Инструкция по эксплуатации

Страница: 16 / 41

16
4. FRONT PANEL DESCRIPTION
1 Amperage / Voltage control - The Amperage / Voltage control selects the desired Amperage
or voltage (depending on mode) withing the entire range of the welding generator. Rotating
this control in a clockwise direction increases the amperage or voltage output. The scale
surrounding the control represents approximate actual amperage or voltage values.
2 Battery Charge Lamp - When the RUN/STOP Switch is turned on the Battery Charge Lamp
will Glow. For normal operation when the engine is running the Battery Carge Lamp will be
off. Should the Charging circuit at Battery fail the Battery Warning Lamp will Turn-on and
the engine will shut off.
3 Oil Pressure Lamp - When the RUN/STOP Switch is turned on the Oil Pressure Lamp will
Not Glow. Should the oil sensor in the engine detect a low oil condition the Oil Pressure
Lamp will turn-on and the engine will shut off.
4 Water Temperature Lamp - Lamp turns on when engine temperature reaches degrees.
5 Fuel reserve Lamp.
6 Arc Control Switch.
7 Process Selector switch : CC/CV - Allows the operator to select the CC (Constant Current)
process or CV (Constant Voltage) process.
ref. T8300KAT.DWG
++
,+
EXPLORER
CIRCUIT
BREAKER
115V 3A
+8
"
REMOTE
TM
PROCESS SELECTOR
ENGINE WARNING SYSTEM
&
DC CURRENT/VOLTAGE REGULATION
!
$
VOLTS
AMPERES
#
!
%
#
$
AMPERE/VOLT
PANEL
!
%
"
OFF
ARC CONTROL
ON
CV
CC
1
RC
A THERMADYNE Company
HERMAL
)
4
TM