THERMAflow Ltd | THERMAFLOW® ELECTRIC COMBINATION BOILER |
Tel: 0870 850 5207
7
0.2
Draining & Filling
CAUTION:
THE THERMAFLOW BOILER WORKS IN A PRESSURISED SYSTEM WHICH MUST
ONLY BE DRAINED, REFILLED AND PRESSURISED BY A
COMPETENT PERSON
.
There is a drain tap fitted to the Thermaflow boiler to drain the primary circuit within the boiler it is located
at the bottom of the appliance.
Further drain taps should be fitted into the pipe-work at the lowest point of the potable water circuit and
the heating circuit and should terminate outside the dwelling in a suitable position.
0.3
Manual Handling Guidance
During the appliance installation it will be necessary to employ caution and assistance whilst
lifting as the appliance exceeds the recommended weight for a one man lift.
DO NOT LIFT THE APPLIANCE BY ATTACHED PIPE-WORK OR COMPONENTS
In certain situations it may be required to use a mechanical handling aid.
Take care to avoid trip hazards, slippery or wet surfaces.
IMPORTANT INFORMATION
0.4
TESTING & CERTIFICATION
The boiler is tested and certified for safety and performance. It is therefore important that no alteration is
made to the boiler, without permission, in writing, from Thermaflow Ltd.
Any alteration not approved by Thermaflow Ltd, could invalidate the certification, boiler warranty and may
also infringe the current issue of the statutory requirements, see section 2.1.2
The unit should be stored in a dry environment and should be handled with care to prevent attached
components being damaged or connections becoming loose.
All
connections should be checked for
leaks after installation
.
0.5
THE UNIT LOCATION
The unit should be preferably located in a cupboard with a minimum dimension of;
W 675mm x D. 740mm x H. 2.4M
The floor to which the unit is placed upon should be capable of withstanding a load of:
278KG
The unit should be positioned in a manner that allows access to all components for future
maintenance.
If located in a cupboard the unit should be positioned with all components facing the entrance to
allow elements to be replaced if required or any of the other components.
