Page 14
SIDE VIEW
FIG. 14 PRSE Wall Mount
FIG. 15 PRSE Floor Mount
PLAN VIEW
STEP B:
Set the bracket on the floor and turn it
until it is oriented properly. The long channel
should be on the top with the free end facing
towards you, one set of mounting flanges should
be resting horizontally on the floor, and the other
set of mounting flanges should be positioned
vertically facing the rear.
STEP C:
Slide the bracket to the desired position.
Note that the minimum (dim. A) and maximum
(dim. B) spacing from the side wall to the center
line of the closest bracket mounting hole is as
shown in the chart above and in Figures 14 and
15.
STEP D:
If you plan to mount the bracket to the rear
wall, slide the bracket back until it is positioned
against the rear wall. If you plan to mount the
bracket to the floor, position the bracket such that
the center line of the rear-most mounting holes in
the horizontal bracket flange are 7/16" in front of
the rear edge of the range side panel when the
range is in its final installed position.
STEP E:
With the bracket properly positioned, use
the bracket as a template and mark the location of
the selected four (4) mounting holes.
STEP F:
Drill four (4) holes at the marked locations.
STEP G:
Using the four (4) screws provided, securely
fasten the bracket.
STEP H:
Carefully slide the range into position.
FOR
THE ANTI-TIP DEVICE TO ENGAGE THE RANGE,
THE REAR EDGE OF THE RANGE SIDE PANEL
MUST BE WITHIN 2" OF THE VERTICAL MOUNT-
ING FLANGE OF THE ANTI-TIP BRACKET. RE-
MOVE ANY LOOSE ITEMS SUCH AS GRATES
AND BURNER CAPS FROM THE TOP OF THE
RANGE, THEN CAREFULLY TILT THE RANGE
FORWARD TO ENSURE THAT THE ANTI-TIP
DEVICE ENGAGES TO PREVENT TIPPING.
Shown From
Left Side Wall
Max.
up to 2
"
Shown From
Left Side Wall
7/16"
STEP 4: INSTALLING ANTI-TIP DEVICE
Min. A
Max. B
Min. A
Max. B