Thermador PRD48JDSGU Скачать руководство пользователя страница 24

Страница: 24 / 98

Using the Cooktop

English 22

Control Knobs

The control knobs for two sealed gas burners, one in front
and one in the rear, are located directly in front of and
below the pair of burners on the control panel. Each burner
has its own control knob. The symbol above each control
knob identifies the burner position on the cooktop.

Operation of the Burners

1. Press in on the knob and turn it counter-clockwise to

the

setting on the knob.

–

The igniter for the selected burner clicks and

sparks.

–

After burner ignition, the igniter stops clicking.

2. Rotate the knob to any flame setting between

and

SIM

–

The blue signal light, between the burner knobs,

will light when adjacent burners are lit. The light will
remain on until the adjacent burners are turned off.

ExtraLow

Burners

The controls for the ExtraLow burners have flame settings
even lower than the standard

SIM

settings.

The drawing shows that the control knob has an additional
range between the

SIM

and

XLO

settings. When the knob

is set within this range, the flame cycles off and on. By
varying the length of time the flame is off and on, the heat is
reduced even further to cook delicate foods. For example,
these very low settings are suitable for simmering and
poaching, melting chocolate and butter, holding cooked
foods at temperatures without scorching or burning, etc.

Operation of the ExtraLow

Burner

•

XLO, the very lowest setting, is achieved by cycling the
flame ON for approximately 7 seconds and OFF for 53
seconds of each minute.

•

When the knob is rotated just beyond the SIM setting,
the flame will cycle ON for approximately 53 seconds
and OFF for 7 seconds of each minute.

•

To vary the amount of low heat, the control can be set
anywhere within the SIM and XLO range marked on
the knob.

ExtraLow

Techniques

•

The type and quantity of food affects which setting to
use.

•

The pan selected affects the setting. Its size, type,
material, and whether a lid is used, all affect the
consistency of the cooking temperature.

•

To maintain a low or simmer heat, bring food to a
rolling boil. Stir well, then cover the pan and lower the
heat to a setting just below SIM.

•

Check periodically to see if the control knob should be
turned to another setting.

•

If an over-size pan is used, the simmer action may
occur mainly in the center of the pan. To equalize the
temperature throughout the food, stir the food around
the outer edges of the pan into the food in the center.

•

It is normal to stir food occasionally while simmering.
This is especially important when simmering for several
hours, such as for a homemade spaghetti sauce or
beans.

•

When lowering the flame setting, adjust it in small
steps.

•

If the setting is too low to hold a simmer, bring the food
back to a boil before re-setting to a higher heat.

•

It is normal not to see simmer bubbles immediately
after the food has been stirred.

•

There may be bubbling when the flame cycles ON and
no bubbles when the flame is OFF. Even when the
flame is OFF, there will be steam and a slight quiver on
the liquid’s surface.

POWERBOOST

The POWERBOOST, or XHI, is located at the right-front
position of the rangetop. It offers the convenience to quickly
boil water, sear steaks, stir-fry vegetables, etc. Use of the
SIM and XLO remains the same as the other XLO Knobs.

Figure 11: ExtraLow STAR Burner Control Knob

OFF

ExtraLow

Range

ExtraLow

Range

ExtraLow

Range