TheraSauna TS4544, Руководство пользователя и инструкция по сборке

Страница: 9 / 20

9
ASSEMBLY INSTRUCTIONS FOR THERASAUNA®
1. Place bottom (Figure 3, page 4) on a solid flat
surface with 5 supporting blocks down. Note: Two
blocks on the top of the base go towards the back.
2. Stand back wall (Figure 2, page 4) on base with
channeled edge up, make sure to center wall along
back edge of base. Note: Base should extend out
from each end of wall.
3. Stand left sidewall (Figure 1, page 4) with
channeled edge up on base at a 90
°
angle to back
wall. Sidewall trim forms a channel for back wall
to interlock with sidewall. The left sidewall is
distinguished with a notch in upper area. This
notch indicates the top of the panel and should be
aligned with the back panel. Insert three furniture
bolts (Figure 11, page 6) through holes in sidewall
and screw into back wall (do not tighten bolts.)
Hex wrench (Figure 12, page 6) is provided.
4. Stand right sidewall on base. Sidewall trim should
interlock back walls. Insert three furniture bolts
through sidewall into back wall (do not tighten).
5. Slide bench support panel (Figure 7, page 5) into
guides on side walls. Note: Plug cord into heater,
if heater cord does not reach rotate bench front
180 , with heater facing front of sauna.
6. Front edge of seat top (Figure 6, page 5) is
finished. With finished edge toward you slide seat
top all the way to back wall so it rests on supports
provided. Seat is reversible to your preference.
7. Stand front wall (Figure 4, page 5) on base, with
channeled edge up. Slide front wall into vertical
channels on both sides and insert three furniture
bolts into holes in left sidewall and right sidewall
in front wall (do not tighten). At this stage begin
to tighten bolts continuing around sauna. Tighten
bolts securely.