Package Contents
ALLCLEAR
™
FILTER:
Please read these instructions thoroughly before use. Failure to follow instructions may
result in equipment damage or failure, losses, injury or death.
DANGER:
To avoid possible electric shock:
• If the power cord has been damaged, DO NOT operate, AllClear™ UV unit should be replaced.
• Prior to installation, inspect the quartz sleeve and UV-C bulb to ensure there was no damage during
transportation.
• After installation, the AllClear™ Filter should be examined to ensure there is no water on parts not
intended to be wet.
• If the AllClear™ Filter shows signs of any water leakage, immediately unplug it from the power source.
• If the AllClear™ Filter falls into the water, DO NOT reach for it. First unplug and then retrieve it.
• Close supervision is necessary when the unit is used by or near children.
WARNING:
To reduce the risk of electric shock:
• Connect only to a properly grounded receptacle, which is serviced by a Ground Fault Circuit
Interrupter and never remove the ground pin from the plug.
• Provide a “drip loop” for the power cord. This is a loop in the cord below the level of the receptacle or
plug that prevents water from traveling along the cord in the direction of the receptacle.
• ALWAYS unplug the AllClear™ Filter from power source when it is not in use, and before installing,
removing or servicing the AllClear™ Filter components.
• If an extension cord is necessary, a cord with a proper rating should be used. A cord may overheat if
the cord is rated for less amperes or watts than the unit rating.
• DO NOT immerse the AllClear™ Filter or plug in water or attempt to use a wet plug.
• The AllClear™ Filter is NOT suitable for use in swimming pools, swimming ponds, or other situations
where bodily contact is made with the water. Although the AllClear™ Filter is designed for outdoor
use, it should never be submerged in water.
Avoid contact with the UV-C light. Light omitted can be harmful to the eyes and skin.
CAUTION:
To reduce the risk of equipment damage or failure:
• DO NOT place the AllClear™ Filter in direct sunshine.
• DO NOT place the AllClear™ Filter near flammable or other dangerous materials or objects.
• ALWAYS unplug the unit if there is no water running through it to prevent over heating.
• The AllClear™ Filter is NOT submersible; do not place the AllClear™ Filter where it might contact or fall
into the water.
• DO NOT operate during freezing conditions. Drain, disconnect and store the AllClear™ Filter in a
protected location.
• DO NOT operate the AllClear™ Filter with a pump larger than the maximum flow rate indicated by
the filter specifications. Operating with a pump larger than recommended can reduce the filters
effectiveness and cause damage to the filter or UV and will NOT be covered under warranty.
The Pond Guy® is not responsible for equipment damage or failure, losses, injury or death
resulting from failure to follow safety precautions, misuse or abuse of equipment.
MODEL
POWER
UV
MAX FLOW
RATE
MAX POND SIZE
(GALLONS)
PLUMBING SIZE
(STEP DOWN BARB FITTING)
POWER
CORD
LENGTH
AllClear™ 1200
120V / 60 Hz
7 Watts
600 GPH
1,200
1”
16’
AllClear™ 2400
120V / 60 Hz
9 Watts
1,600 GPH
2,400
1”, 1¼”, 1½”
* Note: On 1200 filter, four canister buckles are used for securing instead of one canister clamp. Also, 1200 filter includes 2
filter pads instead of 3.
AllClear
™
PLUS Series
A
B
C
B
A
C
thepondguy.com | 866-POND-HELP (766-3435)
15425 Chets Way | Armada, MI 48005
2
3
