Themis RES-XR4-3U, Руководство по установке

Страница: 164 / 184

RES-XR4-3U Installation Manual Version 1.3
D-2
Themis Computer
The RES Audio/USB/Serial Port Custom Module is installed after first removing
one of the existing RES storage drives (any one except the boot drive) then connect-
ing the appropriate I/O cables from the RES Audio/USB/Serial Port Custom Module
to the external devices. After the storage drive has been removed from the system,
cables from the internal RES motherboard are fed through the open drive slot and
attached to the I/O headers on the top surface of the Custom Module PCB, and the
Module is inserted into the vacant drive slot (see
Figure D-2 ). [Note that a RES-
32XR3/FIO is shown in this Appendix, although the Module may be installed into
any RES system.]
Figure D-3 on page D-3 shows the internal connections that are
made between the RES Custom Module and the RES motherboard.
Caution: Because connections must be made internally from the RES Custom
Module to the RES motherboard, the RES Custom Module must be installed at the
Themis factory before being shipped to the customer. Do not attempt to remove the
RES Custom Module from its drive slot unless you have some hardware experience
(see the following paragraph,
Figure D-2 , and Figure D-3 on page D-3.
Figure D-2. Install the RES Audio/USB/Serial Port Custom Module
RES Audio/USB/Serial Port Custom Module
RES-32XR3 / FIO
After attaching header cables through a
vacant drive slot to RES motherboard headers
(and
optional rear-panel audio I/O connectors),
insert the RES Custom Module into
the vacant drive slot.
Header cables