Thelin ECHO-COMSTOCK PELLET E.I. II, Инструкция по установке и эксплуатации

Страница: 5 / 31

ECHO PELLET E.I. II PELLET HEATER
5
WARNINGS
HOT SURFACES! HOT GLASS WILL CAUSE
BURNS. SURFACES AND GLASS ARE HOT
DURING OPERATION AND DURING COOL-
DOWN PERIOD.
DO NOT TOUCH GLASS UNTIL IT IS COOLED.
NEVER ALLOW CHILDREN TO TOUCH
GLASS. ALERT CHILDREN TO HAZARDS OF
HIGH TEMPERATURES.
HIGH TEMPERATURES MAY IGNITE
CLOTHING OR OTHER FLAMMABLE
MATERIALS. KEEP CLOTHING, FURNITURE,
DRAPERIES AND OTHER FLAMMABLE
MATERIALS AWAY FROM HEATER.
FOR USE WITH PELLETIZED WOOD FUEL
ONLY
THIS APPLIANCE NEEDS PERIODIC
INSPECTION AND REPAIR FOR PROPER
OPERATION. CONSULT OWNER’S MANUAL
FOR FURTHER INFORMATION. IT IS
AGAINST FEDERAL REGULATIONS TO
OPERATE THIS APPLIANCE IN A MANNER
INCONSISTENT WITH OPERATING
INSTRUCTIONS IN THE
OWNER’S MANUAL
GENERAL INFORMATION
Installation and repair should be done by a qualified
service professional. The stove should be inspected
before use and at least annually by a service
professional. More frequent cleaning may be
required due to fuel quality, excessive lint from
carpeting, bedding material, etc. It is imperative that
control compartments, burn pot and pot holder, and
circulating air passageways of the stove be kept
clean and free of ash buildup, lint, and dust.
The Echo Pellet Heater has been designed and
approved for burning
PREMIUM WOOD
PELLETS OF HIGHEST BTU OUTPUT AND
LOWEST % OF ASH CONTENT ONLY.
Burning biomass fuels in other forms or poor
quality pellet fuel is not permitted and will void
your warranty and/or could cause a burn back or
house fire.
FOR BEST RESULTS THE WOOD
PELLET FUEL SHOULD BE ¼” DIAMETER
AND APPROXIMATELY 1” LONG.
Store fuel in a covered, dry area. Pellet bags can
absorb moisture and must be kept dry. Never place
bags of fuel next to the heater. Keep fuel away from
combustible materials and moisture.
NEVER use
gasoline, gasoline type lantern fuels, kerosene,
charcoal lighter fluid, or similar liquids to start or
“freshen up” a fire. Keep all such liquids well away
from the stove while it is in use.
Pellet ashes should be placed in a metal container
with a tight-fitting lid. The closed container of ashes
should be placed on a non-combustible floor or the
ground, well away from all combustible materials,
pending final disposal. If the ashes are disposed of
by burial in soil or otherwise locally disbursed, they
should be retained in the closed container until all
cinders have been thoroughly extinguished.
NOTE : During the first few burns (up to 2 – 4 hours)
the high-temperature paint and sealant used in the
manufacture will emit some odor and smoke. Open
doors and windows to the outside for proper
ventilation during the first burn cycle and the curing
of the paint.
SEE INITIAL FIRING PROCESS
beginning on page 15.
Under specific test conditions this heater has been
shown to deliver heat at rates ranging from
16,800
to 26,800 Btu/hr.
This stove must be electrically grounded according
to local codes or, in the absence of local codes, with
the National Electrical Code,
ANSI/NFPA 70-
2013 .