74
DHCP Server Configuration
A DHCP server can be configured to assign IP addresses to devices connected to the
LAN2 port. To configure these ports, choose LAN2 from the System Network
menu.
DHCP Configuration
Item
Description
DHCP Server
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN2 interface.
Start IP
Specifies the starting IP address of the DHCP range.
End IP
Specifies the ending IP address of the DHCP range.
DNS Server
Displayed the DNS server IP address.
LAN3(For the N8900)
LAN3 Configuration
The N8900 supports three Gigabit Ethernet ports for higher service availability. To
configure these ports, choose
Additional LAN 3
from the System Network menu,
and the Additional LAN3 Configuration screen appears. Press Apply to save
your changes.
Additional LAN3 Configuration
Item
Description
MAC Address
Displays the MAC address of the LAN
3
interface.
Jumbo Frame Support
Enable or disable Jumbo Frame Support on the LAN
3
interface.
IP
Specifies the IP address of the LAN3 interface.
Netmask
Specifies the Network Mask of the LAN3 interface.
Gateway
When Thecus NAS as a DHCP server from LAN3, it can have
another route to balance traffic bandwidth for its DHCP
clients
Link Detected
Specifies the LAN3 port link status
Lick Speed
Specifies the LAN3 port link speed
NOTE
The IP Segment of WAN/LAN1 and LAN2 should not overlap.
WARNING
The IP address of the LAN2 interface should not be in the range of the
Start IP address and End IP address.
