www.theatrelight.co.nz
Theatrelight NZ
PO Box 13-159, Onehunga, Auckland, New Zealand
6 Rowe St, Onehunga, Auckland, New Zealand
Tel: 64-9-622 1187, Fax: 64-9-636 5803,
The new setting is displayed for a further 5 seconds, then after a short flash, normal
display is restored.
Note the security times above are correct for a normal DMX refresh interval
(~22msecs). These times may be longer if the DMX refresh rate sent by the control
panle does not adhere to the DMX 1990 standard.
Keys Disable
(6 and 12 chn):
Hold the two top centre Keys until you see a short flash of all mimic LEDs (about 2
secs): the keys are now disabled.
Any key press when keys are disabled gives a long error flash.
Keys Disabled state is shown by a chase up of LEDs 1-12 (1-6) every 10 secs.
Keys Enable
(6 and 12 chn):
Hold the two bottom centre Keys until you see a short flash of all mimic LEDs (about
10 secs): the keys are now enabled.
Set all Channels On/Off/DMX
(12 chn only)
Hold Key 1, then press:
Key 2 - after a short flash all Channels are set Off - all Key LEDs blink on
Key 3- after a short flash all Channels are set On - all Key LEDs blink off
Key 4- after a short flash all Channels are set to DMX control - All Key LEDs are
either on or off (not blinking) depending on the DMX level
Parameter Save
5 minutes after any command change (such as Mode, DMX security, Keys
enable/disable), the new parameters are saved to flash memory. Parameter save is
shown by a chase up/down of all LEDs.
Phase A B C LEDs behaviour
LED On:
correct phase power supply
LED Off:
no phase power supply
LED Flashing:
noisy or intermittent power supply
DMX LED behaviour
LED On:
DMX ok
LED Off:
no DMX connection
Intermittent Flash: noisy or intermittent DMX connection
Regular flash:
DMX start address not in valid range of 1-501 (12 chn) or 1-507
(6 chn)
