All of the linkages can be soldered together for strength. The laser parts have 2 long levers, the one
just under 3” is for the flat car. The other is for the future boxcar and unused on this kit.
The short 3 hole lever for the pivot linkage mounts to the already installed pivot support. The top
prebent strap bolts and acts as a pivot housing. You will need to bend and adjust the strap to fit the
holes. Use the 3 – 0-80x .250” bolts/nuts to mount. I used again 1/16” cotter pins for the linkage
supports where they are cut and terminated before the trucks. All other linkage and hangers are 3/64”
brass wire bend to suit. The clevis I used a 1/32 brass wire used as a pin to the linkage.
