10/2021 V 1.1
VIEW 19.3H
06/16
Using purpose built "Glass Li�ers",
posi�on and sit the Glass Inline Panel
on to the Underframe Gasket and push
against the Return Panel.
WARNING: Do not fix the glass panels
together, this will be later.
Remove and replace the Panel adding
or subtrac�ng spacers as necessary to
level the Panel (to a maximum height
of 5mm inside the Underframe).
Check the Panel is level using a Spirit
Level. If the difference between the
two Panels is greater than 5mm, it may
be necessary to lower the Return
Panel.
Mark/scribe the Underframe at the top
face of the Glass Panel.
If required, mark/scribe the ver�cal
Wall Profile also to the end face of the
Glass Panel.
DO NOT trim the Profiles at this stage.
Carefully li� the Glass Panel out and
put to one side. Remove the Return
Panel, Wall Profile So� Seal, Wall
Profile, Underframe Gasket, and
Underframe Profile and set to one side.
WARNING
The glass is heavy and may
damage the floor or underframe if
handled incorrectly. It is advisable
to use a suitable non-slip
protective mat or piece of carpet.
Never rest the glass across the
underframe as this may cause
damage.
Glass Joint
21
22
23
24
