The Handy THS80, Руководство по сборке и эксплуатации

Страница: 11 / 16

11
PRECISION SPREADERS
SUPPLEMENTARY INSTRUCTIONS
USING YOUR SPREADER
Precision spreaders are designed to spread dry, powdered or granulated, materials thinly and evenly over any
reasonably smooth surface.
Proceed as follows
1. Make certain that the material is dry and “free running”. If in doubt pass it through a sieve with 3mm (1/8”)
mesh to remove lumps.
2. Set rate-setting dial to No2.
3. Fill the hopper approximately ¾ full.
4. Push the spreader forward and open feed gate (push the knob down) whilst in motion. If spread is uneven
or inadequate pull the lever up and set micro-dial to a higher number. Repeat until satisfactory distribution
is obtained.
N.B. ALWAYS MOVE OFF BEFORE OPENING THE FEED-GATE. ALWAYS CLOSE THE
FEED-GATE BEFORE STOPPING.
Even branded materials may vary in grain size, humidity, Density etc. If you are in doubt either (1) Choose
a lower setting than that suggested above or (2) Start at dial setting No.2 and progressively dial higher
numbers until an even spread is achieved. Lock the dial clamp and apply material. This will, give rather
less than the manufacturers of the material recommends.