The Handy THPMT, Инструкция по эксплуатации

Страница: 4 / 20

SPECIFICATION
The manufacturer reserves the right to change the product specification and livery according to continued
product improvements.
Model THPMT
Product Number 193820002
Engine 1.2kw Air Cooled Low Maintenance
Displacement 42.7cc
Fuel Tank Capacity 1200ml
Usage Time for Full Tank Approx. 60mins
Tines 6 Teeth/22.5cm Diameter
Tilling Width 25cm
Tilling Depth 20cm
Unleaded Petrol / 2-Stroke Oil Mixture
Synthetic or Semi Synthetic Oil - 50:1
Mineral Oil - 25:1
Starting System Recoil
Guaranteed Noise Level (L
WA
) <110dB(A)
Net Weight 15kg
IMPORTANT INFORMATION
INTENDED USE
The product is intended to till or cultivate domestic gardens. This product is not intended for commercial use.
The machine should not be used to remove turf and is best used from a pre-dug square of soil to commence
movement.
Generally acknowledged accident prevention regulations and enclosed safety instructions must be observed.
Only perform work described in these instructions for use, any other use is incorrect. The manufacturer will
not assume responsibility for damage resulting from such use.
GENERAL SAFETY INSTRUCTIONS
Read and understand the owner’s manual and labels affixed to the product. Learn its application and
limitations as well as the specific potential hazards. Retain these instructions for future reference. The
operator is responsible for following the warnings & instructions in this manual and on the product.
STAY ALERT
Do not operate the machine while under the influence of drugs, alcohol, or any medication that could affect
your ability to use it properly. Do not use this machine when you are tired or distracted from the job at hand.
Be aware of what you are doing at all times. Use common sense.
AVOID DANGEROUS CONDITIONS
Make sure there is adequate surrounding workspace. Cluttered areas invite injuries.
Keep your work area clean with sufficient light. Keep the area around the machine clear of obstructions,
grease, oil, rubbish and other debris which could cause persons to fall onto moving parts.
INSPECT YOUR MACHINE
Check all bolts, nuts, and screws for tightness before each use, especially those securing guards and drive
mechanisms. Vibration during use, may cause these to loosen.
Form a habit of checking to see that all other tools/equipment are removed from the working area before
turning it on.
Replace damaged, missing or failed parts before using it. Warning labels carry important information. Replace
any missing or damaged warning labels.