Page 1
3
To replace the line or spool:
•
Stop the engine.
• Lay the trimmer on the floor so that the cutting head is facing up.
•
Remove the bump knob/retaining cap by turning it anti-clockwise.
•
Remove
the
empty spool being careful not to lose the spring behind
the
head.
•
Clean the head thoroughly and inspect for any worn or damaged
parts.
To reload the spool with line:-
•
Cut two lengths of spare line 3 metres long.
•
Position each line in the two holes located in the centre of the spool
,
as in Fig. 13,
and wind in the direction of the arrow on the spool
(see Fig. 12) keeping the line tight at all times, as in Fig. 14.
•
Wind the line on until you have about 15cm left
then secure the lines
into
the slots on the tabs
, as shown in Fig. 15.
•
Insert the lines on the spool into the eyelets on the trimmer head
as
in Fig. 16
•
Place the spool on the drive shaft.
•
Release the lines from the tabs by sharply pulling each line while
pushing down on the spool.
•
Push down on the spool to reveal the drive shaft
then p
lace the
bump knob/retaining cap on
to
the drive shaft
as in Fig. 17
.
•
Secure the knob/retaining cap by turning it clockwise
.
If you need to replace the whole spool, follow the in
s
tructions above,
omitting the references to refilling the line.
REPLACEMENT OF SPOOL AND LINE
Содержание THMC
Страница 5: ...Page 6 MAJOR PARTS ...
