The Handy 10740G, Инструкция и каталог запасных частей

Страница: 2 / 4

UNPACKING AND SET-UP
1. Open carton, then remove ramp and shipping boards.
2.
CAREFULLY TURN TABLE UPRIGHT INTO OPERATING POSITION BEFORE REMOVING SHIPPING
CABLE RESTRAINT FROM SCISSOR MECHANISM.
3. Connect foot-operated air valve to 110 psi maximum air supply. The lift may be damaged
and/or personal injury may result if the pressure exceeds the maximum 110 psi rating.
4. Stand clear of lift table, and depress the UP side of foot valve to raise table.
5. To lower table, lift detent bar from safety latch and lower to next position or to floor.
6. Mount ramp to top by inserting ramp tabs into slots in lift top.
NOTE:
If cycle vise is being installed, ramp must be mounted opposite the cycle vise.
OPERATION
1. Loads must be centered on table at all times.
2. Loads must be firmly positioned and secured on table at all times. Tie-down straps
must
be used
in conjunction with the holes provided in the lift top.
3. All moving parts have been lubricated at the factory and should be re-lubricated every 6
months to prevent galling. Grease zerks are located at each end of frame pivot shaft and at
top ends of inside frame assembly.
4. Lightly oil cylinder rod when it becomes dry.
5. Squirt some oil through bleed hole in plate end of cylinder to lubricate piston and its seal every
6 months.
6. Pivot shaft set screws should be checked frequently to be sure they are tight. These are
located at the top end of the inside frame assembly.
OTHER OPTIONS AVAILABLE
Separate installation instructions included with each option.
PART # DESCRIPTION
14476
CV-17 CYCLE VISE
– Vise with rem ova b le wheel stop b uilt into vise
10728
12” SIDE EXTENSIONS
( 2) – Exp a nd s wid th of lift from 24” to 48” inc lud es sta b ilizer
b a r
16011
13” FRONT EXTENSION
– Extend s lift top to 93” for long er wheel b a se m otorc yc les
10736
13” REAR EXTENSION
– Extend s lift top to 93” for long er wheel b a se m otorc yc les
15566
RAMP END EXTENSIONS
– Atta c hes to end of lift ra m p for a m ore g ra d ua l inc line to
p revent b ig g er b ikes from d ra g g ing b ottom .
10737
SNOWMOBILE WING KIT
– Used when lifting snowm ob iles
16355
CE FOOT PEDAL
– Covered foot p ed a l
10732
LIFT DOLLY
– Help s m ove lift while in d own p osition
16010
TOOL TRAY
– Keep s tools org a nized a nd Ha nd y
NOTE: READ ENTIRE MANUAL TO COMPLY WITH ALL SAFETY AND SERVICE PRECAUTIONS.
DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS
ARE FOLLOWED CAREFULLY.