The boss SRCH51101, Руководство пользователя

Страница: 17 / 18

1
7
TROUBLESHOOTING
REMEDY
1. Open propane supply valve
slowly
2.
Replace burner/valve assembly
3. Assure ignitor electrode gap
is 0.158" (4.0mm). Check
wire lead for damage. Replace
ignitor electrode as necessary
1. Relight, hold automatic control
valve button in 45 seconds
3. Tighten connection or replace
thermocouple
4. Replace automatic control
valve assembly
1. Check gas supply; check
regulator output
2. Consult propane gas supplier
3. Replace burner assembly
POSSIBLE CAUSE
1. Propane supply valve closed
on cylinder(s)
2. Blockage in burner/valve
assembly
3. Ignitor electrode not
sparking
1. Not enough warm-up time
2. Low gas pressure
3. Thermocouple loose or needs
to be replaced
4. Automatic control valve
needs to be replaced
1. Low gas pressure
2. Low fuel supply
3.
SYMPTOM
Burner fails to light
Burner lights but goes
out when automatic
control valve button is
released
Maximum burn rate is
low
TROUBLESHOOTING
WARNING: Never attempt to service heater while it is connected
to propane supply, operating, or hot. Severe burns can occur.
2. Check cylinder(s) for proper
gas supply
IMPORTANT Match the color stripe on the hang tag attached to the hose assembly with the color on
the label located near the propane inlet fitting on the heater. Do not use alternates. For this heater, the
regulator must be set as shown in"specifications (page 6)". If there is any uncertainty about the regula
-tor setting,have it checked. A heater which is not working properly must be repaired, but only by a
trained, experienced service person. In-warranty products will be repaired with no charge for
replacement parts. Please include a brief statement indicating date,place of purchase,the
nature of the problem and proof of purchase.
Out-of-warranty products will be repaired with a charge for replacement parts.