The boss SRCH51101, Руководство пользователя

Страница: 16 / 18

1
6
STORAGE & MAINTENANCE
CAUTION: Disconnect heater from cylinder(s) before storing.
WARNING: Never attempt to service heater while it is connected to propane
supply, operating, or hot. Severe burns can occur.
BURNER CHECK
1. Do not store heater while attached to cylinder. Remove the gas supply hose from the cylinder
by turning the fuel gas connector nut clockwise.
2. When the heater is to be stored indoors, the connection between the propane supply cylinder(s)
and the heater must be disconnected and the cylinder(s) removed from the heater and stored in
accordance with Standard for the Storage and Handling of Liquefied Petroleum Gases,
ANSI/NFPA 58 and CSA B149.1, Natural Gas and Propane Installation Code.
Always store cylinders outdoors. Never store cylinder in an enclosed area.
3. Place plastic cover caps over brass fittings on inlet connector and hose/regulator assembly.
4. Store in a dry, clean, and safe place.
1. Keep heater clean.
2. The appliance shall be kept clear and free from combustible materials,gasoline and other
flammable vapors and liquids.
3. The flow of combustion and ventilation air should not be obstructed.Use warm soapy water
for cleaning.
4. Never use flammable or corrosive cleaning agents.
5. Inspect heater before each use. Check connections for leaks. Apply mixture of liquid soap
and water to connections. Bubbles forming show a leak that must be corrected. Correct all
leaks at once.
6. Inspect hose/regulator assembly before each use. If hose is highly worn or cut, replace it
before use. The replacement hose assembly shall be that specified by the manufacturer.
7. Have heater inspected yearly by a qualified service person.
WARNING: Heater shell, top, and heated air from heater is very hot during
operation. Gradually move in closer to heater to observe flame color.
Do not touch heater shell or top. Do not get too close to heated air from
heater.Severe burns could occur.
To check for correct burner flame, look through the ventilation holes in the top of the heater to see
the burner flame.
* The flame is contained within the heater.
* The flame is essentially blue with perhaps some yellow tipping.
* There is no strong disagreeable odor, eye burning or other physical discomfort.
* There is no smoke or soot inside or outside of the heater.
* There are no unplanned or unexplained shut downs of the heater.
The parts lists and exploded view show the heater as it was constructed. Do not use a heater which
is different from that shown. In this regard, use only the hose, regulator and cylinder connection fitting
(called a POL fitting) supplied with the heater.