The boss SRCH51101, Руководство пользователя

Страница: 15 / 18

15
OPERATION
TO START HEATER
2. Fully open the valve on the propane cylinder slowly and wait 15 seconds before step 3.
3. Push in and turn the heater control knob to the "IGN" position.
4. Once ignited, continue to hold the control knob depressed for 30 seconds,then release.
5. If heater does not light, wait 5 minutes and repeat the ignition procedure.
WARNING:
1. Review and understand the warnings in the Safety Information section (page 2).
2. To safely operate this heater, follow all local codes when using this heater.
6. When the burner remains lit, push in and turn the control knob between “HIGH”-“LOW”
to the desired heat setting.
7. If the burner goes out, push in and turn the control knob to the "OFF" position. Check fuel
supply. If fuel supply is OK, repeat the light procedure.
8. To turn off, turn control knob clockwise until it locks in “OFF” position.
TO STOP HEATER
1. Tightly close propane supply valve on cylinder by turning clockwise. Wait 15 minutes for the
heater to cool before handling heater.
3. Always detach the gas supply hose from the heater and the cylinder after each use.
TO RESTART HEATER
1. Wait five minutes after stopping heater.
2. Repeat steps of LIGHTING INSTRUCTIONS.
1. Turn the heater control knob to the "OFF" position.
2. Turn the heater control knob to the "OFF" position.
LIGHTING INSTRUCTIONS: