background image

Important Safety 
Warnings & Instructions

SAVE  THESE  INSTRUCTIONS.

This  manual

contains  important  SAFETY  WARNINGS  and
OPERATING  INSTRUCTIONS  for  the  Basement
Watchdog  Special  battery  backup  sump  pump
system.    You  will  need  to  refer  to  it  before
attempting  any  installation  or  maintenance.

ALWAYS

keep these instructions with the unit so

that they will be easily accessible.

Failure  to  read  and  follow  these  warnings  and
instructions  could  result  in  property  damage,
serious injury, or death.  It is important to read
this  manual,  even  if  you  did  not  install  the
Basement Watchdog backup sump pump system,
since  this  manual  contains  safety  information
regarding  the  use  and  maintenance  of  this
product.  

DO NOT DISCARD THIS MANUAL.

ELECTRICAL PRECAUTIONS

This installation must be in accordance with
the National Electric Code and all applicable
local codes and ordinances.

Risk of electrical and fire hazard.  May result
in death, serious injury, shock or burns.

To  help  reduce  these  risks,  observe  the
following precautions:

• 

DO  NOT

walk  on  wet  areas  of  the  basement

until  all  power  has  been  turned  off.    If  the
main power supply is in a wet basement, call
an electrician.

• 

NEVER

handle the control unit with wet hands

or while standing on a wet surface.

• 

ALWAYS

unplug  the  control  unit  and

disconnect the cables from the battery before
attempting any maintenance or cleaning.

• 

ALWAYS

unplug  the  main  pump  when

installing  or  servicing  the  backup  pump  or
float switch to avoid electric shock.

• 

DO NOT

expose the control unit to water, rain

or snow.

• 

DO NOT

place the control unit on the floor.

• 

DO NOT

pull the cord when disconnecting the

control unit.  Pull the plug.

• 

DO NOT

use an extension cord. The electrical

outlet  should  be  within  the  length  of  the
controller’s  power  cord  and  at  least  4  feet
above the floor.

• 

DO NOT

use an attachment not recommended

or sold by the manufacturer.  It may result in
a risk of fire or injury from an electrical shock.

• 

DO NOT

operate this product if it has received

a  sharp  blow,  been  dropped,  or  otherwise
damaged in any way.

• 

DO NOT

use pump in pits handling raw sewage,

salt water, or hazardous liquids. This system is
for ground water use only.

• 

DO NOT

disassemble the control unit. 

• 

DO

protect  the  electrical  cord  from  sharp

objects, hot surfaces, oil and chemicals.  Avoid
kinking the cord.

• 

MAKE SURE

the supply circuit has a dedicated

fuse  or  circuit  breaker  rated  to  handle  the
power requirements of this system.

When  service  is  required,  contact  Glentronics
technical support at 

800-991-0466, option #3

,

or send an e-mail to 

[email protected]

.

Return the control unit to the manufacturer for
any repairs at the following address:

Glentronics, Inc.

645 Heathrow Drive, Lincolnshire, IL 60069-4205

BATTERY PREPARATION

Sulfuric acid can cause blindness or severe
burns.  Avoid contact with skin, eyes, or
clothing.  In the event of an accident, flush
with water and call a physician immediately.
KEEP OUT OF REACH OF CHILDREN.

To  help  reduce  these  risks,  observe  the
following precautions:

• Someone should be within range of your voice

or close enough to come to your aid when you
work near a lead-acid battery.

• Have  plenty  of  fresh  water  and  soap  nearby  in

case battery acid contacts skin, clothing or eyes.

• Wear  eye  and  clothing  protection  and  avoid

touching your eyes while working with battery
acid or working near the battery.

• If battery acid contacts skin or clothing, wash

immediately  with  soap  and  water.    If  acid
enters  eye,  immediately  flood  eye  with
running cold water for at least 15 minutes and
get prompt medical attention.

!

WARNING: 

Battery  posts  and  terminals

contain lead, lead compounds or chemicals known
to  the  State  of  California  to  cause  cancer,  birth
defects  or  other  reproductive  harm.  Wash  hands
after  handling.  See  www.p65warnings.ca.gov  for
more information.

!

WARNING: 

Battery fluid can expose you to

chemicals  including  strong  inorganic  acid  mists
containing  sulfuric  acid,  which  is  known  to  the
State  of  California  to  cause  cancer.  For  more
information go to www.P65warnings.ca.gov.

BATTERY PRECAUTIONS

Explosive gases could cause serious injury or
death.  Cigarettes, flames or sparks could
cause battery to explode in enclosed spaces.
Charge in a well-ventilated area.  Always
shield eyes and face from battery.  Keep vent
caps tight and level.

To  help  reduce  these  risks,  observe  the
following precautions:

• 

NEVER

smoke or allow a spark or flame in the

vicinity of the battery. 

• Use  the  Basement  Watchdog  control  unit  for

charging  a  LEAD-ACID  battery  only.   

DO  NOT

use  the  control  unit  for  charging  dry-cell
batteries  that  are  most  commonly  used  with
home appliances.

• Be  sure  the  area  around  the  battery  is  well-

ventilated.

• When cleaning or adding water to the battery,

first fan the top of the battery with a piece of
cardboard  (or  another  non-metallic material)
to blow away any hydrogen or oxygen gas that
may have been emitted from the battery.

• 

DO NOT

drop a metal tool onto the battery.  It

might  spark  or  short-circuit  the  battery  and
cause an explosion.

• Remove  personal  metal  items  such  as  rings,

bracelets,  watches,  etc.  when  working  with  a
lead-acid battery.  A short circuit through one of
these items can melt it, causing a severe burn.

• 

ALWAYS

remove the charger from the electrical

outlet before connecting or disconnecting the
battery  cables.    Check  the  polarity  of  the
battery posts.  The POSITIVE (+) battery post
usually  has  a  larger  diameter  than  the
NEGATIVE (-) post.

• When  connecting  the  battery  cables,  first

connect  the  small  ring  on  the  end  of  the
BLACK  wire  to  the  NEGATIVE  (-)  post  of  the
battery, and then connect the large ring on the
end of the RED wire to the POSITIVE (+) post
of the battery.

• 

ALWAYS

keep the cover secured on the battery

box by slipping the tabs through the fittings
on the front and back of the box.

Do not use this system to pump flammable
or explosive fluids such as gasoline, fuel oil,
kerosene, etc.  This system is rated for
ground water use only.

DO NOT use this system in pits handling raw
sewage or other hazardous liquids.

Page 1

!

DANGER

!

DANGER

!

WARNING / POISON

!

DANGER

POSITIVE POST HAS
LARGER DIAMETER

NEGATIVE POST HAS
SMALLER DIAMETER

POSITIVE

POST

NEGATIVE

POST

!

WARNING

Содержание Special CONNECT





















Отзывы: