Page 8
4. Remove the fluid sensor from the battery.
Unscrew the wing nuts. Remove the battery
cables.
5. Clean the battery posts with a battery
terminal cleaner or a wire brush.
6. Clean any corrosion off of the ring connectors on
the ends of the battery wires. Us a stiff brush
or sandpaper.
DO NOT
apply corrosion resisting
sprays or pads to the terminal rings or posts
after you have cleaned them, since this could
prevent the system from charging properly.
7. Replace the fluid sensor in the top of the
battery. Then replace the battery cables,
BLACK to the NEGATIVE (-) post and RED to
the POSITIVE (+) post. Tighten the wing nuts.
Replace the cover on the battery box.
8. Plug the charger
and the blue AC
pump
controller
back into the wall
outlet.
9. If any of the alarms
are sounding, press
the YELLOW button
on the front of the
control panel for one (1) second.
REPLACING THE BATTERY
Risk of electrical shock or battery explosion,
which can cause serious injury or death.
Wear eye protection. Work in a well-
ventilated area. Do not smoke or allow a
spark or flame in the vicinity of the battery.
Avoid dropping metal tools on the battery.
If battery acid contacts eyes, flush with
water for 15 minutes and get prompt
medical attention. Review the safety
instructions on page 1.
REFER TO THE PHOTOS AT RIGHT
1. Unplug the charger and the blue AC pump
controller from the wall outlet.
2. Remove the cover of the battery box by
pushing in the tabs on the front and back,
then lifting up.
3. Fan the area around the top of the battery
with a piece of cardboard (or another non-
metallic material) to remove any hydrogen or
oxygen gas that
may have been
emitted from the
battery.
4. Remove the fluid
sensor from the
top
of
the
battery. Unscrew
the wing nuts
and remove the
battery cables.
5. Remove the old battery from the battery box
and place the new battery in the box. Fill the
battery following the instructions on page 4
or 5.
6. Clean any corrosion off of the ring
connectors on the ends of the battery wires.
Use a stiff brush or sandpaper.
DO NOT
apply corrosion resisting sprays or pads to
the terminal rings or posts after you have
cleaned them, since this could prevent the
battery from charging properly.
7. Replace the battery cables, BLACK to the
NEGATIVE (-) post and RED to the POSITIVE
(+) post. Tighten the wing nuts.
8. (a) If your battery has six (6) caps on the top,
rinse and dry the cap with the extra hole from
the old battery to remove any residue. Replace
the battery cap in the cell that is 2nd from the
POSITIVE post with the cap from the old
battery. Insert the fluid sensor in the cap. (b)
If your battery has two caps, each covering
three (3) battery cells, simply insert the fluid
sensor in the top of the battery next to the
arrow. Replace the cover on the battery box.
9. Plug the charger and the blue AC pump
controller back into the wall outlet.
10. If any of the alarms are sounding, press the
YELLOW button on the front of the control
panel for one (1) second.
!
DANGER
8
7
5
6
2
3
4
Remove
POSITIVE
POST
NEGATIVE
POST
7
5
6
4
2
3
Remove
POSITIVE
POST
NEGATIVE
POST
8a
8b
9
