STEP 4.
Insert the small tab of the lamp panel into the
slot and gently press until you hear it snap into position.
STEP 5.
Replace lamp cover by lining up the four plastic
pins over the holes and sliding into place.
BULB REPLACEMENT
The Thane Q
TM
requires a bulb that is 4.8 volt, 0.5a
STEP 1.
Remove lamp cover as
instructed above.
STEP 2.
Unscrew old bulb and
replace with 4.8 volt, 0.5a
bulb.
STEP 1.
Lift off lamp cover by grabbing both sides of
cover and gently lifting it straight up.
STEP 2.
Remove the lamp panel by lifting up the tab and
pulling up to reveal the battery housing.
Page 11
Page 10
SHUTTING OFF THE GRILL
1. Turn burner control knob(s) clockwise until flame is extinguished.
2. When burner flame goes out, remove the LP canister.
DO NOT TOUCH HOT GRILL PARTS WITH BARE HANDS!
AFTER USE
1. Let appliance cool.
2. Remove drip pans and discard before closing the Thane Q
TM
.
3. Detach LP canister when not in use.
4. Replace canister cap to keep valve clean.
5. Wash grates with non-abrasive cleaner.
6. Grates are dishwasher safe.
STORING YOUR GRILL
1. Clean the grill.
2. Always remove LP canister from grill when
grill is not in use.
3. LP canister should be stored outdoors.
4. If grill is stored indoors, detach and leave the LP canister outdoors.
BATTERY INSTALLATION
The Thane Q
TM
requires 4 (four) AA batteries. To replace batteries:
STEP 3.
Insert batteries with the flat end of the battery
against the spring. The batteries in positions 1 and 2 will
be facing in the same in the direction. The batteries in
positions 2 and 4 will be facing in the opposite direction.
Dome Light Switch
Ignitor Switch
Left Burner
Control Knob
Right Burner
Control Knob
