Thales MissionLink, Руководство по установке

Страница: 22 / 51

2-4
Installation Guide 84465 Rev. B
1. Assemble Items No. 1 (3x) and 2 (3x) (included with Antenna Mounting Hardware Kit
PN 1100790-501) to antenna at the three perimeter mounting points as shown in Figure
2-2 and hand tighten.
NOTE
Do Not tool tighten or torque the mounts. Doing so could cause
damage to the unit.
2. Place Antenna in desired final operating location on ferrous surface with all three
magnets in contact with surface. Failure to make contact with all three magnets may
cause loss of mount integrity.
3. Connect coaxial cable as shown in Figure 2-1 and hand tighten.
4. Run coaxial cable, Figure 2-1, to approximate location of the Terminal Unit installation
location.
NOTE
IMPORTANT: Antenna cable connection should be secured
tightly and covered with protective rubber boot or self-
vulcanizing tape (not included) to prevent corrosion.
NOTE
IMPORTANT: When removing the antenna with magnetic
mounts from a metal surface, do not pull up on the coaxial cable
or connector. This could damage the antenna.