TGB X-MOTION 250, Руководство пользователя

Страница: 206 / 219

B. Connect megga meter "-" terminal to circuit negative cable.
Note: User megga meter "A" current position. ■ Turn main switch
to "OFF" position. Inspection: Check if there is electrical current.
If no current, check the main switch and wire harness for short
circuit.
4-3-4 STARTER MOTOR
(1) Please place main stand to park the
motorcycle for inspection.
(2) Turn the main switch to "OFF" position before maintenance.
Disconnect the battery ground circuit.
To ensure safety, turn the main switch to "ON" position and
check if the motor has operated.
Disassembly:
© Remove starter motor cable. © 2 starter
motor attaching screws. © 2 motor case
attaching bolts. © Starter motor.
Check Starter Commutator Inspection:
(1) Check continuity between segments.
Note:A. If continuity is good, then it is normal.
B. If no continuity, then it is broken.
(2) Check continuity between segments and
armature shaft.
Note:A. If no continuity, then it is normal.
B. If continuity is good, then it is broken.
(3) Clean the commutators if there is metal powder between segments.
(4) Check the removed parts for damaging, burning (discoloration), and wearing.
Replace with a new if necessary.
(5) Check brush length.
Note: A. Initial standard brush length is 112.5 mm.
B. If brush length is smaller than 8.5 mm, please replace with new brush.
Inspection: Check continuity of the brush holder. Note: A. If there is no
continuity, it is normal.
B.If there is continuity, it is broken.
Please replace with new one. Installation: install in reverse
order of disassembly procedures.
204
PDF created with pdfFactory Pro trial version www.pdffactory.com