TEXWRAP 2219 Series, Руководство пользователя

Страница: 18 / 71

Motion Trims
TEXWRAP MOTION TRIMS The purpose of this feature is to increase the throughput of any certain
product. This is accomplished by starting the opening or closing action of the seal bar before the staging
eyes tell the machine to do so.
FRONT BAG TRIM
In a normal seal cycle, the product does not begin the transfer into the seal area
until the seal bar is completely open. Front Bag Trim uses a number from 0 to 100 to determine when the
product should start moving into the seal area, even if the seal bar is not completely open. A number of 50
would mean that the seal bar will be 50% open when the transfer will begin. Depending on the product
height and speed, a low number could allow the product to run into the seal bar. To turn this feature off,
set Front Bag Trim to 100.
REAR BAG TRIM In a normal seal cycle, the Rear Bag timer must finish before the seal bar is allowed
to close. Rear Bag Trim uses a number from 0 to 100 to determine when the seal bar should start the
closing process, even if the Rear bag timer is not done. A number of 50 would mean that when 50% of
the Rear Bag timer is left, the seal bar will begin to close. To turn this feature off, set Rear Bag Trim to
100.
Press the PREV (UP) or NEXT (DOWN) button to highlight the setting to change. The user may press
the RAISE or LOWER button to adjust the value, or type in a desired setting. When done press ENTER.
To return to the previous screen press the EXIT button. To return HOME, press the button directly below
the label HOME.
18