Textron JACOBSEN R-311 69166, Техническое руководство по ремонту

Страница: 247 / 402

6-16 4203781 First Edition
HYDRAULICS
6
Lower Circuit Schematic and Theory
of Operation
System Conditions:
• Engine running
• Right, left, and/or front lift/lower lever(s) in the
LOWER position
Oil Supply to Lift Valves
Hydraulic oil is drawn from the hydraulic oil tank by
section 1 of the gear pump assembly. Before entering the
gear pump assembly, the inlet oil is filtered by a
100-mesh screen to remove any debris. Operating
pressure oil from section 1 of the gear pump is routed to
port “P” of the control valve and flows through the 4.5
gpm (lpm) priority valve. The four-section gear pump will
need to produce a flow rate of 4.5 gpm (17 lpm) before
the priority valve opens to supply oil to the lift valve.
The priority valve will supply oil flow to the steering valve
before allowing oil flow to the lift valve, to ensure
maximum steering control at any engine rpm range.
Lower Circuit
Operating pressure oil enters the lift valve body at the
“IN” port, and flows to the 1500 psi (103 bar) relief valve
and to each of the spool valves. With the lift/lower levers
in the LOWER position, operating pressure oil flows
through the spools. Oil is directed to the detent load
check spools. The spools are shifted, and open the ports
to allow trapped oil in the cylinder circuit to flow to the lift
spools.
Gravity pulls the cutting units down, pulling against the lift
cylinders. Oil from the piston end of the lift cylinders flows
into the lift valve body at port “B,” through the detent
valves and lift valves. The oil exits the lift valve body
through the “OUT” port, through the weight transfer valve
to the hydraulic tank.
Circuit Relief
The lift system is protected by the 1500 psi (103 bar)
relief valve. If the pressure on the pilot line of the relief
valve reaches 1500 psi (103 bar), the valve will open,
dumping operating pressure oil through the “OUT” port of
the lift valve body, through the weight transfer valve to the
hydraulic tank.