Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
6
EK1550LT and EK1550LX Battery-powered Crimping Tools
Procedure for Using Kearney PH14 Dies
1. No die holder assemblies are needed. Dies fit
directly into tool.
2. Select proper die set for fitting to be crimped.
Note: Do not use non-butting dies (crimps con-
trolled by tonnage) in this tool, as damage could
occur to connectors and/or conductors.
3. Install upper die in hole in top of “C” head. Snap in
place with top die retaining plunger (6).
4. Install lower die in hole in end of piston. Snap in
place with bottom die retaining plungers (6).
Adapter Kits
Procedure for Using Kearney PH2 Dies;
48824 Die Holder Kit
1. Install 48823 PH2 die spacer assembly into hole
in top of “C” head. Snap in place with retaining
spring plunger (6).
2. Install upper 48825 die holder assembly into hole in
die spacer assembly. Lock in place with die spacer
retaining screw.
3. Install lower 48825 die holder assembly in hole in
end of piston. Snap in place with bottom die holder
retaining spring plungers (6).
4. Select proper die set for fitting to be crimped.
Note: Do not use non-butting dies (crimps con-
trolled by tonnage) in this tool, as damage could
occur to connectors and/or conductors.
5. Slide die into place in top die holder tight against
shoulder. Detent screw will snap into groove of
die. Lock in place with top die retaining cap screw.
Repeat operation for other die entry.
PH2 Die Holder Kit 48824 contains:
(1) 48823 and (2) 48825 Die Holders
PH14 DIES
BOTTOM DIE
RETAINING SPRING
PLUNGERS (6)
TOP DIE HOLDER
RETAINING SPRING PLUNGER (6)
TOP DIE HOLDER
RETAINING SPRING PLUNGER (6)
48823 PH2
DIE SPACER
ASSEMBLY
DETENT SCREWS
TOP DIE
RETAINING SCREW
48825 PH2
DIE HOLDER ASSEMBLIES
BOTTOM DIE
RETAINING SCREW
TOP DIE HOLDER
RETAINING SCREW
BOTTOM DIE HOLDER
RETAINING SPRING PLUNGERS (6)
