854DX Electric Bender
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
9
Service Instructions
(cont’d)
g. Drive the rollpins into the holes leaving 1/4" pro-
truding on both sides.
h. Orient the shaft so that the thick part of the
eccentric is at 3 o’clock as viewed from the rear
of the bender.
i. Place the adjuster over the rear eccentric so that
the original hole used is on the right side.
j. Insert the hex screw through the retainer so
screw head abuts the flange and screw into the
top hole.
k. Insert the second screw into the original hole
and rotate the shaft until the screw can be
threaded into its hole.
Roller Stop Plate
1. Remove the roller assembly (refer to previous
instruction).
2. Remove the roller support assembly (refer to
previous instruction).
3. Remove the two screws securing the roller stop
plate.
4. Disconnect the trip switch cable.
5. Slide the roller stop plate off the shafts.
6. Remove the cam spring.
7. Remove the flat head screw, nut, washer, spacer,
and cam.
8. Reassemble in reverse order.
Outer Control Box
1. Remove the two screws at the bottom front of the
control box (right side of bender).
2. Remove the two screws at the top rear of the
control box and remove the wire cover.
3. Lift the outer control box up and outward.
4. Pull off the two motor leads from the circuit board
noting their orientation.
5. Pull off the encoder cable from the circuit board.
6. Pull off the trip switch wire harness.
7. Reassemble in reverse order noting the following:
Connect motor leads to same tabs as removed
from.