Textron Genesis G2, Инструкция по эксплуатации, Страница: 23 / 27

24
Fault Diagnosis
* Pages 12-15 if a swivel head is used instead of a nose assembly.
† Page 15 if a swivel head is used instead of a nose assembly.
Item numbers in bold refer to the general assembly drawing and parts list on pages 20-21.
More than one Air leak Tighten joints or replace components
operation of the Insufficient air pressure Adjust air pressure to within specification 5
trigger needed to Lack of lubrication Lubricate tool at air inlet point 7
place fastener Worn or broken jaws Fit new jaws 8-10*
Low oil level or air in oil Prime tool 22-23
Build up of dirt inside the nose assembly Service nose assembly 9†
Tool will not grip Worn or broken jaws Fit new jaws 8-10*
stem of fastener Build up of dirt inside the nose assembly Service nose assembly 8-10*
Loose jaw housing Tighten against locking ring 8-10*
Weak or broken spring in nose assembly Fit new spring 8-10*
Incorrect component in nose assembly Identify and replace 8-10*
Rotary valve incorrectly adjusted Read ‘Operating Procedure’ 7
Jaws will not release Build up of dirt inside the nose assembly Service nose assembly 9†
broken stem of Jaw housing, nose tip or nose casing
fastener not properly seated Tighten nose assembly 8-10
Weak or broken spring in nose assembly Fit new spring 8-10*
Air or oil leak Tighten joints or replace components
Low oil level or air present in oil Prime tool 22-23
Cannot feed next Broken stems jammed inside tool Empty stem collector 4
fastener Check jaw spreader is correct 8-10*
Adjust air pressure to within specification 5
Rotary valve incorrectly adjusted Adjust as in ‘Operating Procedure’ 7
Slow cycle Lack of lubrication Lubricate tool at air inlet point 5
Low air pressure Adjust air pressure to within specification 5
Build up of dirt inside the nose assembly Service nose assembly 9†
Tool fails to operate No air pressure Connect and adjust to within specification 5
Damaged trigger valve 41 Replace 20-21
Loose base cover 35 Tighten 20-21
Loose stem collector Tighten retaining nut 21 20-21
Fastener fails to break Insufficient air pressure Adjust air pressure to within specification 5
Fastener outside tool capability Use more powerful Genesis tool.
Contact Textron Fastening Systems
Low oil level or air present in oil Prime tool 22-23
S Y M P T O M P O S S I B L E C A U S E R E M E D Y PA G E R E F
Other symptoms or failures should be reported to your local TFS authorised distributor or repair centre.