Textron EZGO Workhorse ST 350, Руководство пользователя и руководство по обслуживанию

Страница: 12 / 72

OPERATION AND SERVICE INFORMATION
3-4
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
ENVIRONMENTAL CONCERNS
As a responsible user, practice respect for all wildlife and their habitat.
Respect private property and comply with all local laws and regulations
governing the use of light duty utility vehicles. Do not tamper with the
exhaust system or governor. The exhaust system has been tuned to
the engine for maximum performance. Removal or modification of the
exhaust is annoying to other people and will not improve the perfor-
mance of the vehicle.
To prevent severe injury or death
while driving, be aware of the follow-
ing:
Environmental hazards such as steep slopes, overhanging
limbs, etc.
Danger of fire when vehicle is operated over dry combusti-
ble organic material.
When driving, be aware of environmental hazards such as steep
slopes, overhanging limbs, etc. Be aware of the danger of fire when the
vehicle is operated over dry combustible organic material.
OPTIONAL WINCH
This vehicle may be equipped with an optional winch (not available on
ST SPORT). Read, understand and follow all of the following informa-
tion on the operation and use of winch before attempting to operate it.
OPERATION OF THE WINCH
The winch can be mounted at the front or rear of the vehicle and
moved to accommodate different situations. At the front, it is mounted
under the center of the front cowl to a bracket attached to the front axle
as shown (Ref Fig. 2 on page 3-4). At the rear, the winch is mounted
upside down in the hitch receiver.
If mounting winch at rear of vehicle, the winch must
be mounted upside down.
Before moving the winch, unplug the winch connector from the wire
harness. To move the winch from one end of the vehicle to the other,
remove the spring pin, pull out the clevis pin and remove the winch
mount tube from the receiver. Move to opposite end of vehicle and
install by inserting clevis pin and securing with spring pin. Plug the
winch connector into wire harness.
The winch remote control plugs into the receptacle on the seat support
(Ref Fig. 3 on page 3-5).
To unwind the cable, locate the clutch knob on the winch. Pull out knob
and rotate 90° to lock out. Using handsaver bar, pull cable from winch
drum. Leave at least five turns of cable on drum. Re-engage drum by
! !
Fig. 2 Winch Mounted to Vehicle
Front Axle
Clevis Pin
Spring Pin
Winch shown mounted at front of vehicle