Texi Tutu, Руководство по эксплуатации

Страница: 138 / 140

136
TEXI Tutu operation manual
CARING FOR YOUR MACHINE
To ensure the best possidle operation of your machine, it is necessary to
keep the essential parts clean at all times. Always disconnect the machine
from power supply by removing the plug from the socket-outlet.
CLEANING THE FEED DOGS AND HOOK AREA
1. Raise the needle to its highest position.
2. Remove the needle plate (1)
3. Remove the bobbin case (2)
4. Clean the feed doge and hook area with the lint brush.
NOTE: Put drop of sewing machine oil on the hook race as indicated
by the arrows A.
5. Replace the bobbin case with the projection (3) positioned against
the spring (4). Replace the needle plate.
HELPFUL HINTS
Problem Cause Correction
Upper thread breaks
1. Machine not properly threaded.
2. Thread entwined around bobbin.
3. Needle inserted correctly.
4. Thread tension too tight.
5. Thread of incorrect size or poor quality.
1. Re-thread machine.
2. Remove entwined thread.
3. Re-insert needle.
4. Radjust thread tension.
5. Choose correct thread.
Lower thread breaks
1. Bobbin threaded incorrectly.
2. Bobbin wound unevenly or too full.
3. Dirt on the bobbin holder. 1. Re-thread the bobbin.
2. Rewind the bobbin.
3. Clean the holder.
Machine skips stiches
1. Needle inserted incorrectly.
2. Bunt or blunt needle.
3. Incorrect size of needle 1. Re-insert needle.
2. Insert new needle.
3. Choose correct size needle for fabric.
Fabric puckers
1. Machine not properly threaded.
2. Bobbin threaded incorrectly.
3. Blunt needle.
4. Threaded tension too tight. 1. Re-threaded machine.
2. Re-thread the bobbin.
3. Insert new bobbin.
4. Readjust thread tension.
Machine make loose
stitches or loops
1. Bobbin threaded incorrectly.
2. Machine not properly threaded.
3. Tension not adjusted properly. 1. Re-thread the bobbin.
2. Re-thread machine.
3. Readjust thread tension.
Treader does not thread
needle eye
1. Needle is not raised.
2. Needle inserted incorrectly.
3. Bent needle. 1. Raise the needle.
2. Re-insert needle.
3. Insert new needle.
Machine does not feed
properly
1. Lint and dust accumulated around feed dog. 1. Clean the feed dog area.
Needle breaks
1. Fabric pulled while sewing,
2. Needle is hitting the presser foot.
3. Needle inserted incorrectly.
4. Incorrect size needle or thread for fabric being sewn. 1. Do not pull fabric.
2. Select correct foot and pattern.
3. Re-insert needle.
4. Choose correct size needle and thread.
Machine will not run
1. Cord not plugged into electrical outlet.
2. Power switch is not turned on.
3. Bobbin winder spindle is pushed to the right.
4. Presser foot is not lowered.
5. Buttonhole sewing mode
* Buttonhole lever is not lowered completely.
* Buttonhole foot is not attached. 1. Insert plug fully into outlet.
2. Turn on the switch.
3. Push spindle to the left.
4. Lower the foot.
5.
* Lower the buttonhole lever.
* Attach the buttonhole foot.
Machine runs
with difficulty
1. Dirt or lint accumulated in the hook race and feed dog.
1. Remove the needle plate and bobbin holder
and clean the hook race and feed dog.