Premier Elite 5Ci-W Internal
Installation Manual
INS655-3
3
Symbol
Description
The battery pack should be connected here after installing the batteries.
Powering the sounder on for the first time starts the learn process. Once learned the "POWER"
jumper should be left in the "ON" position.
If you need to relearn the sounder, the link should be moved to the OFF position for a minimum of
1 second.
Enables or disables the comfort LED's. Disabling the LED's significantly increases battery life.
The sounder on time is dictated by this jumper position and is independent of the Bell On
time in the control panel. If however the panel bell time is shorter than the jumper setting
selected, the panel will over ride the jumper setting.
Only Lithium AA 1.5V Type batteries should be used
Alkaline batteries should not be used, they will have a much shorter lifespan and can freeze and
fail to operate at -5
C
Used Batteries should be disposed of according to the manufacturers instructions.
The quoted battery life is an estimate and will depend on the site conditions.
Learning the Sounder
As with all
Ricochet
enabled devices, the sounder should be learned to the control panel along with all other devices BEFORE it is installed
in it's final location.
The
Premier Elite 5Ci-W
is learned to a Zone on the control panel in the same way that
Ricochet
enabled detection devices are. The Zone
type and
Ricochet
Device Mode is automatically assigned based on the type of device being learned. In the case of the sounder the Zone
Type is set to "Custom" and the
Ricochet
Device Mode is set to Device Specific. These should not be changed. Zone attributes 1 & 2 and
Chime options will be ignored for
Ricochet
enabled Sounders.
You can learn the device from first power up following
"Confirm Devices"
or from the dedicated
Ricochet
Learn menu.
The 5Ci-W has no Learn Switch, learning is initiated by connecting the batteries via the Power Jumper
To learn the 5Ci--W to the system follow the diagram below.
YES to Select:-
Learn Ricochet
y
y
Learn Device?
Zone ??? N?,E??
Power up Device!
N?,E?,D?? - 20s
Learn Device to
Zone ??? N?,E??
y
y
y
y
y
y
n
n
U
N
N
If you need to delete the device from the system you should first put it into "hold off " mode and remove the batteries
.
If the device will not learn to the system check that all batteries are installed correctly.
