1 Mounting and Assembly Instructions
●
Using the backplate of the unit (or the template on the rear of the carton) mark the positions of
the three mounting screw holes
(A)
,
and cable entry hole
(B).
●
Drill and plug the screw holes as marked.
●
Using a long masonry drill bit, drill a hole through the wall for the cable.
●
Pass the cable through the grommet in the cable entry hole
(B)
and strip the cable using the
guide on the backplate. Mount the unit to the wall using the three screws provided.
●
Make the required connections to the terminal block as described in sections 3 and 4.
●
Configure the jumpers as described in section 2.
●
Replace the lid and tighten screw.
2 Jumper Configuration
Battery (BATT) (F)
Once installed, this jumper must be moved to the ON position to connect
the battery. This will activate the automatic 5 second sound test.
The LED’s will not illuminate until the hold-off voltage is applied.
SAB / SCB Operation (E)
Move the jumper to SCB position to minimise the current drawn from the
control panel. A reduction in sound level occurs in SCB mode.
Tamper Mode (G)
This jumper controls the behaviour of the sounder when the tamper switch is opened.
ON The siren will self-activate when the switch is opened in accordance
with BS4737
OFF The siren will not self-activate but will still open the tamper loop to
the panel. Activation off the sounder on ‘bell tamper’ is controlled by
the panel.
Series Tamper (H)
This link must be cut when the tamper loops of two
sounders are connected in series to the same control panel.
Tone (K)
By moving this jumper the tone of the sounder can be altered. This feature
can be used to distinguish two sounders mounted in close proximity.
3 Cut Off Timer
The sounder has a fixed 15 minute cut off timer.
Off
On
Tamp Mode
On
Slow
Fast
Batt
Off
SCB
SAB
Tone
Series
Tamper
2
GB
