
8
Note: The spacer blocks are for rear ejection only!
Otherwise they should be removed.
Warning: If the two blocks
aren’t mounted. The
mower will have difficulties to dispose the grass.
Mulching plug: Illustration M7-2
1. Insert the mulching plug and remove side
discharge guard, if you want to mow with
mulching functionality.
NB Don’t use the grass collector
Important: Remember to remove the mulching plug,
when using the grass collector.
Side discharge guard: Illustration M7-3*
1. Lift the side guard and insert side discharge
guard. Then insert the mulching plug in rear
discharger to mow with side discharge
function. NB
Don’t use the grass collector
*Note: Not all models do have side discharge guard
Cable Adjustment
The following cables may be necessary to readjust:
Illustration A1
1. Cable for drive
2. Cable for engine brake
3. Cable for throttle cable
Note: The choke cable cannot be adjusted!
Adjusting the drive cable: Illustration A1-1
If you experience slack in the drive cable, this can be
solved simply by tighten or loosen the bolt on the cable.
1. Tighten turning clockwise - loosen the cable.
2. Tighten turning anti clockwise - tighten the
cable.
Adjusting the engine brake cable: Illustration A1-2
If you experience slack in engine brake cable, this can
be solved simply by tighten or loosen the bolt on the
engine block.
Adjusting the throttle cable: Illustration A1-3
If you experience slack in revolution cable, this can be
solved simply by tighten or loosen the bolt on the
engine block.
Battery (Electric starter)*
Charge the battery before use
Before the electric start function is used, the battery
must be charged for 5 hours. Put the charger plug into
the hole in the battery and connect the charger to a
power supply. See illustration. A4
Charging during the season
The battery is charged a little during use, buy it will
likely be necessary to charge the battery a couple of
times during the season - depending if the number of
start/stops of the engine. Put it for charging for around 5
hours.
Storage of battery
The battery must always be stored dry and warm during
the winter. Never expose it for low temperatures.
Charge the battery completely before storing and then
place the lawn mower in a place where it is not exposed
to frost. Alternatively cover the battery with a thick
carpet or similar, If the mower is in a shed/garage
where there may be cold.
Charge battery 1-2 times during the winter to make sure
the battery keeps it full capacity.
Incorrect storage can damage the battery, and is not
covered by warranty.
*Note: Not all models do have Electric starter
Operation
Always check and refill oil before the start!
Read and apply the instructions given in the
enclosed start guide!
The oil level should always be between min. and max
on the dipstick. Fill with SAE-30 oil. There should be
total 0.6 liter oil in the engine. Use only unleaded 95
octane fuel to the engine. Never overfill the tank.
Cutting height adjustment: Illustration F1 (the
illustrations may vary from your actual model)
The mower has 6 different heights. The cutting height
ranges from 28 mm to 75 mm
Start:
Never start the mower directly on long grass.
Recoil with primer, illustration F2
1. Push the primer several times, first time push
1-3 times, if necessary supplement with up to
3-5 times.
Note: It is not possible to drown engine
2. Hold the handlebar for the engine brake; this
will release the engine brake.
3. Pull the recoil starter gently until you feel
resistance in the rope, then pull quickly and
energetic. Do not at any time let go of the
recoil starter but slide it gently into starting
position.
4. Hold the bar for self-propelled in order to start
mowing
Recoil with choke, illustration F3-1
1.
By cold engine set the choke lever on ”Choke”-
By warm engine set the choke lever on ”Run”
2. Move
the throttle lever to full “Rabbit”
3. Hold the handlebar for the engine brake; this
will release the engine brake.
4. Pull the recoil starter gently until you feel
resistance in the rope, then pull quickly and
energetic. Do not at any time let go of the
recoil starter but slide it gently into starting
position.
5. Adjust the throttle lever if necessary and return
the choke lever in the ”run” position. (only cold
engine)
6. Hold the bar for self-propelled in order to start
mowing.
Note:
As long as operating the mower, the bar for
engine brake must be engaged.