F.
If the earth auger suddenly stops because of overload the gas throttle is realease in
order to declutch. The engine shall be stopped and the obstacle shall be removed from the
drill.
ASSEMBLY OF EARTH AUGER
A.
Mount the handle on the engine by the means of an appropriate screwdriver.
B.
Mount gas cable and wire for stop switch.
C.
Fill the fuel tank with a mixture 25 : 1 (4%) of gasoline and oil. At the first 20 hours,
however, you shall use a mixture of 20 : 1 (5%). You must NEVER mix directly in
the tank. You shall use an appropriate container.
D.
Mount the drill on the shaft to the reduction gear box and tighten with the screws and
bolts.
START OF (COLD) ENGINE
A.
Open for the supply of gasoline.
B.
If the engine is cold the choke is moved to Close or the choke is moved to the
middle.
C.
Pull the start cord until the engine starts.
D.
Move the choke to "Open" and let the machine idle in 2-3 minutes.
Note. At the first 10 working hours the manchine should run by moderate speed.
The drill should not run at highest speed without load.
STOP OF ENGINE
A.
Slowly release the gas throttle until the engine idles.
B.
Press the Off-button placed on the top of the earth auger.
C.
Close for the supply of gasoline when the engine is turned off.
MAINTENANCE
Carburettor : After every 50 working hours max and min. revoulutions shall be tested and
the float chamber shall be cleaned. Inspect the idle function and if necessary adjust the idling
screw either clockwise or anti-clockwise. When idling the clutch is declutched and the drill
doesn t turn.
