12: 48 Mbps (OFDM)
13: 54 Mbps (OFDM)
14: MCS 0
15: MCS 1
16: MCS 2
17: MCS 3
18: MCS 4
19: MCS 5
20: MCS 6
21: MCS 7
-e, --preamble=VALUE TX preamble for 802.11 rates ONLY. Long:0, Short:1. Default: Long
-r, --pattern=VALUE TX data pattern. See the following for the complete list. Default: 0 (All 0)
0: All 0
1: All 1
2: Incremental
3: Decremental
-l, --packet_size=SIZE TX Testing packet SIZE. Range: [24, 1400]. Default: 1400
-g, --delay=VALUE TX delay in between packets in milliseconds. Packetized TX only. Range:[100, 1,000,000].
Default: 100
-n, --amount=VALUE TX maximum number of packets. Continuous & Packetized only. Range:[0, 1,000,000]. 0 for
infinite amount. Default: 0
-o, --cca_override TX CCA override enable. Default: non-overriding.
-s, --cca_threshold=VALUE TX CCA threshold value. The channel is considered as occupied when signal strength is
above this setting. Default: 2 (-68dBm)
0: MIN (-88dBm)1: LOW (-78dBm)2: DEFAULT (-68dBm)3: MED (-58dBm)4: HIGH (-48dBm)5: MAX (
-38dBm)
-a, --dest_mac=MAC TX destination MAC address WITHOUT colons. For example, if the MAC address is 01:23:45:67:
89:AB, enter 0123456789AB instead. Case insensitive. Default: 01:23:45:67:89:AB
-y, --country_code=VALUE TX Country Code in two ASCII characters. Letters will be converted to upper case. Options:
US, EU, JP. Default: US
RX (Reception):
-R, --rx RX testing and retrieves statistics. The statistics will be shown as:
1st line: <# valid packets>, <# FCS error packets>, <# address mismatch packets>
2nd line: <Average RSSI in management frame>, <Average RSSI in other frames>
3rd line: RSSI historgram. <greater than -48dBm>, <-48dBm to -55dBm>, <-56dBm to -63dBm>
, <-64dBm to -71dBm>, <-72dBm to -79dBm>, <less than -79dBm>
4th line: Rate historgram, lowest to highest. The list order is identical to the rate/
modulation option.
5th line: Timestamps in micro-seconds: Starting time, Stats collecting time, Elapse
-d, --report_period=N RX statistics reporting period, every N seconds. If set to 0, RX statistics will only
report at the end.
Range: [0, 65535]. Default: 0
-p, --report_percent Report RX histogram in percentage format. If not set, default is in amount of packets.
Pow (Power):
--POW, --pow=VALUE
--POW_CMD_LOW, --power_cmd_low=VALUE
Set power command.
1-100: Low Power time
--POW_CMD_HIB, --power_cmd_hib=VALUE
Set hib command.
1-100: Hib Power time
Please contact TI for any question with regards to this program.
CLI Version
SWRU471B – FEBRUARY 2017 – REVISED AUGUST 2020
SimpleLink™ Wi-Fi® CC3x20, CC3x3x Radio Tool User Guide
17
Copyright © 2020 Texas Instruments Incorporated
