Texas Instruments DS90UB953-Q1, Руководство пользователя

Страница: 5 / 54

4 Major Components
Figure 4-1 illustrates major DS90UB960-Q1EVM components.
1. Quad Mini-Fakra connector for FPD-Link III interfaces. There is also a Quad Mini-Fakra to 4x Single Fakra
coax cable assembly (not shown) for interfacing the EVM to up to four sensor modules
2. Samtec QSH type connectors for interfacing the CSI-2 I/Os to downstream processors
3. Switches for configuring DS90UB960-Q1 functional modes
4. USB2ANY connector for interfacing the EVM to a PC
5. Connectors for accessing DS90UB960-Q1 I2C Ports
6. Connectors for accessing DS90UB960-Q1 GPIOs
7. Barrel jack type connector for powering the DS90UB960-Q1EVM from a single 12V/1A supply
8. Connectors for selecting PoC voltage source
FPD-LINK III I/O
MIPI CSI-2 OUTPUTS
FUNCTION CONTROLS
USB2ANY CONNECTOR
I2C BUS
1
2
3
4
5
GPIO 6
POWER SUPPLY 7
POC CONFIGURATION 8
1
2
2
3 4 5
6
7
8
Figure 4-1. Interfacing to the EVM
To demonstrate the functionality, the following components are also required (not included):
1. At least one DS90UB953-Q1EVM or a camera module (Up to four may be used)
2. USB to Mini USB cable OR I
2
C host controller that support clock stretching (Such As USB2ANY)
3. Power supply capable of supporting 12V, 1A load
4. Optional: MIPI-CSI-2 output analyzer or Host Processor
www.ti.com Major Components
SNLU226B – FEBRUARY 2018 – REVISED APRIL 2021
Submit Document Feedback
DS90UB960-Q1EVM User's Guide 5
Copyright © 2021 Texas Instruments Incorporated