Texas Instruments bq25970, Руководство пользователя

Страница: 5 / 22

www.ti.com
Test Summary
5 SLUUBR4A – February 2018 – Revised December 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
bq25970 PWR893 Evaluation Module
2.2 Equipment Setup
Set up the equipment using the following steps:
1. Set PS for 7.5-V DC output, 3A or above current limit and then turn off the supply.
2. Connect the output of PS to J1 (VAC and GND) as shown in Figure 1 .
3. Turn on the battery simulator, set to constant voltage mode and output to 3.6 V. Turn off (disable) the
load. Connect load to J2 (VOUT and GND) as shown in Figure 1 .
Figure 1. Test Setup for BQ25970
4. Connect the EV2x00 USB interface board to the computer with a USB cable and from I
2
C port to J3
with the 4-pin cable. The connections are shown in Figure 2 .
Figure 2. Connections of the EV2300 Kit