11
Mounting
Mounting (illustration 3-9):
1. C
onnect guide bar by inserting both side the supplied
bolts and swing
nut.
Insert the
lower handle closed up
the motor housing and fasten the round finger screws
. (3)
2. Connect middle handle to lower handle and fasten
with finger screws. (4)
3. Connect upper handle to middle handle and fasten
with finger screws. (5)
4. Mount cable holder to lower or middle handle (6)
Grass catcher (illustration 7-8)
1. Insert bracing in grass bag (7)
2. Attach grass bag on bracing by click and fitting it
into place. (8)
3. Fitting fully assembled grass catcher to lawn raker
:
•
Lift the safety guard.
•
Make sure the discharge chute is clean and
free from debris.
•
Fit the fully assembled grass catcher onto
location points at the rear of the deck.
•
Let safety guard fall onto the top of the grass
catcher to lock it in place.
Use without grass catcher:
Note: The lawn raker can be used without the grass
catcher attached. Make sure that the safety guard goes
down and block the discharge chute.
Working depth adjustment
The aerator/scarifier cylinder has variable depth
adjustment position: -12 ~ +6 mm.
When you want to move the aerator to outdoor, you
should always rotate the adjustment button to the
position 0 to protect the aerator cylinder.
The aerator/scarifier cylinder is subject to wear in use
due to the way in which it works . The more intensively
the machine is used, the greater the wear on the
blades/springs.
Hard or very dry ground accelerates wear, as does
excessive use of the machine.
Depending on the ground hardness, e.g. after a long
dry perioid, where the ground/lawn is hard, it is
recommended to start working in one of the higher
depth positions to avoid damage on the machine.
After check the work result, the working depth can be
increased step-by-step until the wanted result is
achieved. Never begin working in lowest postion!
Operation
Important! Use with both batteries at the same time.
In order to work with full power, the machine must be
used with both batteries installed.
Make sure both batteries are fully charged before use.
The machine cannot be used, if one battery is removed
or it is almost drained for power.
Never use the machine if the grass is longer than
75 mm and remember to empty the grass catcher
regulary. Always start use the machine with in one
of the higher working depth positions.
Starting
1. Press and hold the safety button. Squeeze the
switch lever towards the handle.
2. Release the safety button.
Stopping
1. Release the switch lever.
Make sure the blade stoppes rotating
before switching “on” again !
Do not rapidly switch on and off !
IMPORTANT:
Do not continue use the lawn raker,
when the grass catcher is already full. This can
overload the motor, as high heat can occur.
Make sure to check and empty the graas catcher often.
It can quickly become full, if there is a lot of moss in the
lawn or the working depth is set to a deep position.
When to use a lawn raker
Do not use the scarifier when the soil is very hard and
dry. It can damage the belt.
Use the scarifier in early spring and autumn, where
the soil is normally moistures and soft.
Working pattern
(illustration 13)
It will be useful to start working from at a fix point close
and to work your way away from there. Work the lawn
at a suitable angle from the fix point.
Warning:
If the working condition does not allow the
motor to work at full speed, the motor power will drop.
If you hear a change in sound, stop working. Release
the switch lever and raise the working depth. Failure to
do so could damage the machine.
