10.1.2 Direct Power from the Battery
The power supply may be taken
directly from the battery
of the vehicle being
worked on through a
power supply cable
connected to specific diagnostic
cables.
If the battery is in the rear part of the vehicle, we recommend
connecting the tool directly to the power supply points coming from the
battery that are available near the area in which you are operating.
Use the battery power only when specifically requested by the
software.
1.
NAVIGATOR
2.
Diagnostic cable with power supply shunt*
3.
Power supply cable
(*) The diagnostic cable can be different from the one shown in the figure.
Proceed as follows:
1.
Connect the diagnostic cable to the tool's diagnostic connector.
2.
Connect the power supply cable to the diagnostic cable.
3.
Connect the cable's clamps to the battery's terminals making sure you respect
the polarities indicated on the cables.
The
green LED
stays on if the tool is properly supplied.
26
