Tevion DIGITAL MINI SATELLITE SYSTEM, Руководство пользователя

Страница: 82 / 88

Helpline No. UK/Northern Ireland 01422 263270 Rep. Ireland 1890 812049 Helpline No. UK/Northern Ireland 01422 263270 Rep. Ireland 1890 812049
82
Helpline No. UK/Northern Ireland 01422 263270 Rep. Ireland 1890 812049
APPENDIX I
PORTABLE SATELLITE TV SYSTEM
Portable Satellite Dish Alignment Instructions & Information
Satellites are located every 3 degrees in a geostationary orbit
35,000 kilometres above the earths surface at the equator which is
known as the Clarke Belt. No matter where you are on the earths
surface the satellites will always be located at the same position the
only thing that changes is the elevation as you move further north
or south.
Satellite transmissions are low power high frequency; in order to
obtain useable signals you need clear line of site between your dish
and the satellite. Any obstruction in the way i.e., buildings / towers
/ power lines can and will affect the signals received, in some cases
eliminating the signals altogether. Selecting a fixing position for
your dish is therefore critical to the success of the installation. In an
open field situation there should be no problems unless something
large is parked between you and the satellite. A built up area is
somewhat more problematic, as a general rule of thumb look to
place the dish as high as possible, the provided cable will allow a
reasonable height to be achieved. A small difference in the location
of the dish can have quite a significant effect on signals received.
Assemble the dish as per the enclosed instructions. Ensure cable
connections have been made correctly There should be no
connection between the inner and outer sheath, if you find you have
a connection it is likely a small strand of outer sheath has bridged
to the inner core on one of your connectors. Do not turn on the
power to your receiver.
Connect the cable to the LNB on the dish (previously assembled as
per instructions), uncoil the cable from the dish to the receiver. You
will see that to uncoil the cable properly will require the twist to be
removed from the cable, this can only be achieved properly with
one end disconnected, once you have the cable laid out with no
twists, connect the other end to the LNB connection on the receiver
unit. Ensure your scart connected to the TV is made correctly using
the TV connection point on the receiver.
Power up the TV, power up the Sat system, ensure the TV is in AV
mode you should see an output from the receiver showing no
signal.
1 Press menu on the remote control