10
• KB 22 CR
Remote control
A 3 Volt button battery CR2025 is required to operate
the remote control .
The battery is already installed in the remote control unit
on shipping and is protected by a strip of plastic . You will
see this plastic strip on the back of the remote control .
Simply remove it with care . The remote control is now
ready for use .
Danger
Health hazard!
If the battery belonging to the product is swal-
lowed, this may result in severe internal injuries
and even death .
• Keep both new and used button cell batteries so that
they are not accessible for children .
• If the battery compartment can no longer be closed
securely, do not use the product further and keep it so
that it is not accessible for children .
• If you suspect that a button cell battery has been swal-
lowed or ingested in any other way, seek the immedi-
ate attention of a physician .
Danger
Danger of chemical burns!
Leaking battery acid may lead to chemical
burns .
• Do not allow battery acid to come into contact with
skin, eyes or mucus membranes . In case of contact with
acid rinse the affected part immediately with plenty of
plain water and if necessary see a doctor .
Danger
Danger of explosion!
Batteries (particularly lithium batteries) can
explode if used improperly .
• Never attempt to recharge batteries .
• Only use batteries of the same or equivalent type .
• Do not heat or short circuit batteries or rechargeable
batteries and do not dispose them in fire .
• Do not expose batteries and storage batteries to direct
sunlight .
Changing the battery
1 . Hold the remote control face down .
2 . Unscrew the cross-headed screw using a screwdriver .
3 . Pull the battery compartment out of the remote control .
4 . Take out the old battery (see „Batteries and recharge-
able batteries“ on page 23) .
5 . Place the new battery into the holder, making sure
that the “+” symbol is visible on the battery and on the
holder .
6 . Replace holder and push the compartment back in until
it clicks .
7 . Screw-tighten the cross-headed screw .
Functionality
The remote control relays the control signals by means of
infrared light . It is therefore important that you point the
remote control in the direction of the unit . Make sure that
the infrared light is not obstructed by objects .
Fluorescent or energy-saving light bulbs installed in the
facility of the unit may impair the function of the remote
control or even make it impossible .
