CHAPTER 4
OPERATION
4-2
Displays of series DN-109NN, DN-119NN, DN-129NN and DN-189NN
Enter to configure parameters.
To configure the display parameters, the Advance key
“
” must be pressed and held for
three seconds. After this, the first parameter will be displayed, showing the most significant digit
flashing.
There are two options:
1-Modify the parameter value.
•
By pressing the Advance key
“
”, you can select values and the parameter
number correlatively.
•
Press
“
” to visualize again the parameter number.
•
To increase the parameter value press the key
“
+
”. It increases the digit value
selected till arrive to the maximum value and go on to the minimum value in the
next press.
If the parameter inserted is not compatible with the equipment, the parameter
will not be accepted. For instance, our equipment have a parameter code for each
protocol (“ 2” ISO 1745, “ 3” ModBus … “ 10” Profinet, etc). A display of the DN-NN
series, which in this version only works with Profinet, will not accept another
parameter than “ 10” .
2-Select another parameter.
U
se the key “
” to blink the desired parameter, and select the new one using the key “
+
”.
The parameter number is:
-
2 digits displays: the left digit with the decimal dot activated.
-
3 or more digits displays: the third digit starting on the right.
You will end the parameter configuration, selecting the parameter F and pressing the
advance key (“
”) to exit.
