TESY AquaThermica Compact HPWH 3.2 100, Руководство по установке и обслуживанию

Страница: 10 / 94

Pos. Description Pos. Description
1 27 Lower tank temperature sensor
2 Compressor 28 Wall hung brackets
3 Electronically regulated expansion valve 29 Magnesium anode
4 Low pressure safety switch - refrigerant 30 Dielectric sleeve Mg anode
5 High pressure safety switch - refrigerant 31 Flange seal
6 Two-way valve (defrost) 32 Flange cover
7 Filling Needle - High pressure 33 Bolts for flange
8
Filling Needle - low pressure
34
Manually reset safety thermostat (90oC)
9 Condenser inlet (High pressure) 35 Cover
10 Condenser outlet (Low pressure) 36 E-Heater
11 Centrifugal fan 37 Hot water feeding pipe
13 Bolts M6 38 Cable terminal
14 Upper plastic cover 39 Cable clamp
15 Back and lateral plastic shells 40 Inlet jet pipe (‘piston” effect) – part 1
16 Front plastic shell 43 Inlet jet pipe (‘piston” effect) – part 2
17 Controller box cover 44 Inlet jet pipe (‘piston” effect) – “O” ring
19
Condenser compressor
45
Inlet jet pipe (‘piston” effect) – part 3
20 Transformer 46 Condensator
21 Condenser fan 47 Heat insulation
22 Main PCB 48 Safety thermo switch 80
o
C (automatic reset)
3.2. Unpackintg
4. DESIGN CHARACTERISTICS (Fig.6; 7; 8; 9)
10
The unpacking operations must be carried out carefully so as not to damage the appliance.
Please follow the described steps bellow Fig.3:
- Using a cutter, cut the straps 7.
- Pull upwards the cartoon box 1.
- Remove the upper EPS plate 2
- Gently take the appliance out of the cartoon tray 4
After having removed the packaging, make sure that the unit is intact. If in doubt, do not use the equipment and seek help from
authorized technical staff.
In conformity with environmental protection regulations, make sure that all the accessories supplied have been removed
before discarding the packaging.
After having removed the packaging, make sure that the unit is intact. If in doubt, do not use the equipment and seek help
from authorized technical staff.
In conformity with environmental protection regulations, make sure that all the accessories supplied have been removed
before discarding the packaging.
WARNING!:
Packaging items (staples, cardboard boxed, etc.) must not be left within the reach of children as
they are dangerous.
WARNING!:
It is not permitted to place the upper component of the device under any form of stress during the
product handling and installation stages because it is not of a structural nature. ( Please see Fig.4 & Fig.5)
WARNING!:
While handling, do not catch the unit onto upper plastic panels! There is a risk to damage them!
(Please see Fig. 4 & Fig. 5)
Note: at the manufacturer’s discretion, the type of packaging may be subject to change.