Tessier DUALSKI, Инструкция по эксплуатации и техническому обслуживанию, Страница: 8 / 23

8
3. SYSTEM FOR CARVING OUT TURNS
Explanations according to figures 3 and 4:
On the Dualski, the tilt angle of the skis is different in relation to the seat, depending
on the chosen configuration: F, M or P.
These configurations correspond to "angle plates" (1) of varying heights. These can
be replaced later on, as required.
F = Facile (Easy): The ski tilt angle is less significant than the tilt angle of the seat.
This makes the swivelling of the skis and side-slipping easier. This configuration is
advisable for those beginning as well as those with more serious disabilities.
It’s also
the configuration we recommend when the Dualski is used with the piloting bar.
P = Performant (Advanced): The tilt angle is more important as with the F
configuration. The Dualski is more difficult to ski with, but it offers better
performances. This configuration is recommended for good skiers.
C = Carving: This configuration allows a very incisive skiing style and is reserved to
very good skiers. With this configuration it becomes hard to make the Dualski sliding.
The maximum angulations angle are: F = 51°, P = 55°, C = 59°
Replacement of the angle plates « F », « P » or « C »
Replacement method for the angle plates
:
Note : for this operation, do not touch the tilt adjustment system (2) of the skis.
It is advised to first replace a side and then the other and to operate in a dry place.
1- Loosen the 2 « locknuts » of diameter 8 at the points 3 and 4 and remove the
screws.
2- Replace the plates by positioning the engraved letter F, P or C upwards. Respect
the positioning of the 3 serrated cup washers (A).
3- Screw back correctly the two nuts (with a dynamometric spanner, the torque is 2.4
mKg). If the nylon collars of the nuts are damaged, then replace them.
4- Do the same for the other side.
5- Verify that skis are flat.